Issue Can the points, outputs and dialer be enabled and disabled from RPS? Solution No, This can only be done from the panel or a keypad attached to the panel. If any of the hard wire points are disabled then follow the steps below to enable points 1-8. Mux points 9 - 255 can be enabled using the "all" command if points 1 - 8 are enabled individually first. To Enable Points Press the Disable Button on the keypad. Press 2 Enable Press 1 Inputs Press 2 Individual Enter the point # (001 - 255) follow by # Repeat steps 3 – 5 until Points 1 -8 are enabled Press 1 Inputs Press 1 All Press the * Clear Button 4 times Follow the steps as above to enable Dialer - NAC's and Relays.