Output A can be configured as a Form C, Com reference or as a Dry contact depending on how you put the jumper under the panel cover.
This article will help you to find out how you can configure output A (1) on the B Series Panel.
1 Select Panel Wide Parameters:
2 Under Panel Wide Parameters > Select Communicator:
3 Change your Primary Path Device to Cellular IP Path 1:
4 Next, go to Enhanced Communication:
5 Double-Click the Network address to input your Central Station Receiver’s IP address.
6 Set your Supervision Time.
Note: this should also match what is in your central station receiver to eliminate erroneous communication trouble.
⚠️ Be sure to notify you Central Station to add your area 1 account number, supervision rate and enable the receiver for Re-synchronization.
Are Radion Wireless and B Series Keypads compatible with D7412Gv4/ D9412Gv4/ D7212GV4 Control Panels?
Radion Wireless and B Series Keypads are only compatible with D7412GV4 and D9412GV4 on firmware ver 2.0 or newer panels.
D7412Gv4 or D9412Gv4 ver 1.0 can be upgraded to ver 2.0, however older SDI keypads will lose most of their functionality as part of the upgrade
The D7212GV4 CANNOT be upgraded. Hence it will never be compatible with either of those devices.