Security: Intrusion

How to correct the D1260 Command Center display: 'Incorrect Panel' that displays when properly programmed.

How to set the supervision time for individual points.

How to program  entry delay for motion detectors with a built in popit.

Part numbers D7212B, D9112B, D7212B1, D9112B1, D7212, D7412, D9112, D9124, D9412, D7412G, D9124G, D9412G, D7412GV2, D9124GV2, D9412GV2, D7412GV3, D9412GV3, D7412GV4, D9412GV4,

How to determine the values to enter for the Poll Rate and Ack Wait Time. Note: The calculation described is only be required on legacy control panels.  The B8512G/B9512G and GV4 types only need a Receiver Supervision Time selection.  The Poll Rate, Ack Wait and Retry count will automatically populate.  The formula for determining Poll Rate and Ack Wait Time is as follows: Panel setting: Poll Rate + Ack Wait + ( Retry Count X Ack Wait) Receiver setting: Panel Poll + Ack Wait Panel setting = Receiver setting Example:    Panel Setting: Poll Rate = 240; Ack Wait = 10; Retry Count = 5 Panel setting: 240+10+ (5 X 10) = 300 Receiver Settings: Poll = 240; Ack = 60 Receiver setting: 240 + 60 = 300 300 = 300 Refer to the the following site for more information on setting up Conettix Devices www.conettix.com/Downloads.aspx

How to locate User Authority settings for Cycle, Unlock and Secure door in the D5200 Programmer.

How to Passcode Protect RPS Connection to the panel.

How to work with IP Communicator supervision in GV4 panels.

How to interpret the message Network Modx Cable Open.

How to interpret Sub Users when promoting a panel account to GV4 Series.