Overview
When wireless points are faulted, they display as 'Short' to the panel. When the wireless point tamper switch is faulted it will display as an 'Open' to the panel.
Issue
The panel when using a D8125INV and wireless points shows normal/faulted when point transitions from normal to off normal but the control always shows shorted.
Solution
Problem may be caused by another point expander connected to the control panel. Remove D8125INV from control panel and determine if points go missing. If points remain active (normal, faulted, etc) the control panel is interfacing with the points through another addressable point expander.
Part numbers D7412G, D7412G, D9124G, D9412G, D7412GV2, D7412GV2, D9124GV2, D9412GV2, D7412GV3,D7412GV3, D9412GV3, D7412GV4, D7412GV4, D9412GV4, B8512G, B9512G, D8125INV, ISW-D8125CW, ISW-D8125CW-V2, FA400, EN4200
The panel is not reporting card access events to the central station. D9412G,D7412G,D7412,D9412,D7212G, D9412GV2, D7412GV2, D9412GV3 Version 8.00 to Version 8.09, D7412GV2 Version 8.00 to Version 8.09
While troubleshooting Conettix problems there are occasions when network traffic fails to pass on a particular port. Determining whether or not the port is already in use, and therefore not available to the current configuration, is a valuable troubleshooting tool
How to use the EN1210W or ISW-EN1210W with external contacts.
The EN1210W or ISW-EN1210W will not go normal when the external contacts are strapped out.
How to interpret the 'Check Device' display on a D1255 or D1260 keypad.
Why does the keypad display "Check Device"?
How to locate which point generated the 'Check Device' display and modify programming to prevent the display.
