How to program a shared area and sequence of operation of a shared area in conjunction with two associate areas.
D9412G,D7412G,D7212G,D7212,D7412,D9112,D9412G, D9412GV2,D9412GV3,D9412GV4,D7412GV2, D7412G, D7412GV3, D7412GV4, D7212G, D7212GV2,D7212GV3,D7212GV4
How to determine which points are available for programming using the D8125MUX.
D8125MUX, DS7457, DS7457I, DS7457IF, DS7460, DS7460I, DS7461I, DS7465, DS7465I, DS7052, DS7051, D7050, D7050-BB, MX835, MX934, MX794Z, MX250, MXB2W, D5060.
How do you enable basic Openings and Closing reporting by user on the 7000/9000 series panel?
D9412,D7412,D7212,D9412G,D7412G,D7212G,D9412GV2,D7412GV2,D7212GV2,D9412GV3,D7412GV3,D7212GV3,D9412GV4,D7412GV4,D7212GV4
Program configuration of a DS7432 module on a D8125 Mux system
D9412,D7412,D7212,D9412G,D7412G,D7212G,D9412GV2,D7412GV2,D7212GV2,D9412GV3,D7412GV3,D7212GV3,D9412GV4,D7412GV4,D7212GV4,D8125 MUX
Issue
Trouble connecting to the D4412 with RPS / RAM IV using the DX4010i.
What dip switches need to be set to make the DX4010i connect to the panel?
What type of cable is needed between the DX4010i and the Laptop or PC?
Solution
RAMIV / RPS needs to be revision 3.6 or higher.
Set the address 0 (Installer's mode) Dip Switches 6 and 8 in the off postion on the DX4010i.
Use a NULL cable to connect the DX4010i to the Laptop or PC.
For remote programming connection, use the RJ-16 to molex connector to the Aux / Data header.
Lock the Installer or Reset Pin on the panel.
In the RSP/ RAMIV Connection screen change the connection type from MODEM to ENHANCED DIRECT, then click connect.
*If connected to a D4412 panel and the address is set wrong on the DX4010i then a message of "INVALID RAM PASSCODE" may be generated.
What would cause the data call button not to appear on the screen after selecting the communicate button when trying to connect to a panel using WDSRP1?
WDSRP,WDSRP2
