Security: Intrusion

How to interpret the B520 Auxiliary Power Supply Module status LEDs. The Heartbeat, battery and AC LED's are used to indicate the operational status of the B520 Auxiliary Power Supply.

How to determine if the D5360 is compatible with the GV3 panel.

How to determine the max distance the DX3010 can be remote located from the control panel. The maximum distance that the DX3010 can be remote located from the control panel is determined by whether or not an auxiliary power supply is used to power the DX3010.

How to determine the max distance the DX2010 can be remote located from the control panel. This distance is determined by whether or not the DX2010 is supplying auxiliary power to devices. The DX2010 has the capacity to provide 12 VDC at up to 100 mA from the Aux Output terminals to power external devices such as motion detectors.

Related Products B426 Version

How to troubleshoot the mail configuration in Intrusion alarm panels.

How to: How many B201 2-Wire Powered Loop modules are allowed the B-Panel? Can the D125B be used on the B-Panel?

Article describes the D8229 limit for card data

Pinout for crossover cable

Describes using 2 readers on a D9210b or D9210c module.

Bosch Security Knowledge Base Related Products D6600 D6200 D6640 D6641

Related Products B3512 B4512 B5512 B930 D7212GV4 Ver2+ D7412GV4 Ver2+ D9412GV4 Ver2+

1 Select Panel Wide Parameters:   2 Under Panel Wide Parameters > Select Communicator:   3 Change your Primary Path Device to Cellular IP Path 1:   4 Next, go to Enhanced Communication:   5 Double-Click the Network address to input your Central Station Receiver’s IP address.   6 Set your Supervision Time. Note: this should also match what is in your central station receiver to eliminate erroneous communication trouble.   ⚠️ Be sure to notify you Central Station to add your area 1 account number, supervision rate and enable the receiver for Re-synchronization.

How to configure the output in GV4 ver.2? Default: 0 Selections: 0 to 8 (increments of 1) Use this parameter to activate an output when the point goes into alarm. The output does not activate for Trouble nor Supervisory events. Reset the output by clearing the memory from the keypad display. The outputs used can be on an output module installed on either the Zonex bus or the SDI2 bus.   *Notice that the Relay will activate only when the point goes in to alarm, not when it changes to an off-normal state. Follow the steps from this article to accomplish the BFSK relay functionality.