Security: Intrusion

How to program  entry delay for motion detectors with a built in popit.

How to determine how many EN4200 Receivers can be used with the B810.

How to set the supervision time for individual points.

How to correct the keypad response No RF Module when adding Inovonics RF Points.

How to use the D4412/D6412 for only Wireless Panic points.   When none of the wireless panics will trip into alarm.   

How to work with Output Profiles. What are Triggers? Should Output Profiles be used in place of Area Wide or Panel Wide Outputs?  

This article details a possible cause to an ARP entry error message

How to determine the values to enter for the Poll Rate and Ack Wait Time. Note: The calculation described is only be required on legacy control panels.  The B8512G/B9512G and GV4 types only need a Receiver Supervision Time selection.  The Poll Rate, Ack Wait and Retry count will automatically populate.  The formula for determining Poll Rate and Ack Wait Time is as follows: Panel setting: Poll Rate + Ack Wait + ( Retry Count X Ack Wait) Receiver setting: Panel Poll + Ack Wait Panel setting = Receiver setting Example:    Panel Setting: Poll Rate = 240; Ack Wait = 10; Retry Count = 5 Panel setting: 240+10+ (5 X 10) = 300 Receiver Settings: Poll = 240; Ack = 60 Receiver setting: 240 + 60 = 300 300 = 300 Refer to the the following site for more information on setting up Conettix Devices www.conettix.com/Downloads.aspx

Part numbers D7212B, D9112B, D7212B1, D9112B1, D7212, D7412, D9112, D9124, D9412, D7412G, D9124G, D9412G, D7412GV2, D9124GV2, D9412GV2, D7412GV3, D9412GV3, D7412GV4, D9412GV4,