Fire

The license key is not stored in plain text therefore is not possible to view, but the associated order number can be identified.

Part numbers D1005, DS250, MX250, D7050, D7050TH, D285, D7050DH, D263THS, D273, D273ES, DS260, DS282, DS282-CR, DS284, DS284-CR, DS284ES, DS250TH, DS250DH, DS282TH, DS282THS, DS282THC, DS284TH, DS284THS, DS284THR, DS284THSR, DS284THCS, DS284THC, DS284IS, DS284THES, MX250, MX250TH, D286, D263TH, D263THS, D263THC, D273THR, D273THSR, D273THC, D273THCS, D273THE, D273THS, D273TH, D273IS, MX250DH, MX280, MX280TH

Part numbers FPA-1000, FPA-1000-UL, FPA-1000-V2

How to upgrade the FPA-1000 from Version 1 to Version 2.

Part numbers FPD-7024, D7024, DS9400, DS9400I, DS9400M,DS9431, D7039, FPE-7039

Part numbers FPD-7024, D7024, DS9400, DS9400I, DS9400M, DS9447, DS9436, D7033, D7036, FMR-7033, FMR-7036

Part numbers FPD-7024, D7024, DS9400, DS9400I, DS9400M

Part numbers FPD-7024, D7024, DS9400, DS9400I, DS9400M, DS9447, DS9436, D7033, D7036, FMR-7033, FMR-7036

How to interpret DBL when displayed on the FPD-7024 or D7024.

Part numbers FPD-7024, B426, B420, DX4020, B450, B440, B441, B442, B443, B444

Check out this article and find out where are the FSM Alarm and Events logs stored and what is the size limit

If FSM needs to be connected to a new panel (network), then proceed as it is described in this article:

This article explains how you can reset the FPA-1000, FPA-1000-UL, and FPA-1000-V2 panels.

When using Wheelock / Cooper / Eaton Exceeder LED 3 Strobes and Horn Strobes on a UL Listed Bosch Fire panel a DSM or SM Wheelock Sync Module is required.

In cases where RPS configuration cannot be loaded please follow the instructions from this article.

The controller is showing faults but when you access the faults option no errors/fault messages are shown, message 'no suitable element' is shown. Why?

This guide gives a example of how to check that OPC is receiving commands and transmitting to controller.

This is how to troubleshoot where turning the key to the Test position does not put the smoke detector inside the duct enclosure into alarm, which will likely be due to the coil is missing.

Any related HW change in the FSM server will lead to license not being valid and will need to be transferred.

The operator 10000 is shown when detector fault/ Fire is acknowledged on the controller when no operator is logged in (e.g. Operator 2), by pressing the Acknowledge button.