Fire

To silence all NAC's of one panel (FPA-5000/Avenar) from the map in FSM Step-by-step guide   Insert a sensor on the map of FSM Under sensor properties choose: General: Add symbol: FIRE_Panel_FPA_BG Settings: Driver Instance: the panel / compound where the FSM is belongs to Address-> e.g. Panel 1-10.1 ! Please pay attention: there are other “Panel” possibilities to choose. Please do not choose Panel 1-10 (Communication)! After inserting the settings click “ok” Then Apply At the map when you right click the panel symbol you will get the commands as shown below.   If there is a fire alarm, you can right click at the panel and then click at “silence on”. Please be sure, that then every NAC which is belonging to this panel is “silenced”. Additional: there is also a command "silence scope" which then has the effect, that the whole scope will be silenced.

Live time event printing is supported. To enable it, add a xml file in program data folder with the name of the printer.

This article explain what should be done if new detectors are added to the system. 

Follow this step-by-step guide and learn how you can use keypad programming to configure FPD-7024 IP communications

The goal is to have a fully illuminated field of view for the installed AVIOTEC/s. Testing is required for every installation to make sure, that the area is illuminated correctly with full coverage and no reflections, aberrations or other. 

This article contains a step-by-step guide about how you can set the field of view (FoV) of AVIOTEC IP starlight 8000

Here it is the overview of the sensitivity settings for flame and smoke detection to adjust the camera to the application of the customer

Check this article and find out what's new in FSM version 5.6.1

This article contains the FSM - Anomalies symbols and their description

This article contains the standard settings/ minimum detection size for smoke or flame of AVIOTEC IP starlight 8000

In this article you will find out the type of lens mount of AVIOTEC & the difference between C-mount/ CS-mount lenses

Follow the steps from this article to see the labels from the sensors in FSM which are configured in RPS

Follow this step-by-step guide from this article and find out how to stop and restart the FSM Server service

This article explains if possible to install Fire monitoring system (FSM) in a virtual environment

Is always recommended to backup the database before running the default process. Find out in this article the steps to restore default FSM (Fire Monitoring System) configuration

This article gives answers to frequently asked questions regarding the AVIOTEC IP Starlight 8000 Video-based fire detection

In this article you will find the amount of Pixels, Resolution and Scale of AVIOTEC IP Starlight 8000 Video-based fire detection

This article explains the field of view (FoV) functionality of AVIOTEC IP Starlight 8000 Video-based fire detection

Follow the steps from this article to configure FPD-7024 to communicate using Cellular or Ethernet network communications. How to configure the FPD-7024 for network communications using keypad programming.

Follow the steps from this article to access the Point Description programming.