Issue
How can I setup Open/Close on a 2000 series panel?
Solution
Using RPS/RAMIV
1. Connect to the control via modem/RPS and receive all panel data and save to your RPS database.
2. Go to the Reports section of the program.
A. Turn on All-On reports by selecting Yes.
B. Turn on Part-On reports by selecting Yes.
3. Save your changes and send the changed data back to the control. Test it out.
Using 5200
1. Latch the installer clip on the control panel and receive a fresh copy of the panel data.
2. After you see Receive Successful on your 5200, go to the Reports section of the program.
3. Using the white SPACE bar on the 5200 press it to toggle NO to YES to turn on O/C for both ALL ON and PART ON.
4. Press the red SEND LOAD key, disconnect the programmer and unclip the installer switch. Test it out.
Overview
New RF Receiver Trouble, Receiver ‘Jammed’
When used with RF Receivers with firmware 9.0 (or later), D2212Bs with revision 3.03 firmware (or later) can display two distinct trouble conditions. The receiver trouble display is expanded to two lines.
Issue
RCVR # TROUBLE 2111
# is the receiver number (7 or 8).
RCVR # TROUBLE 1211
# is the receiver number (7 or 8).
Solution
2111 in the second line indicates that no sensor has been heard from in a calculated interval. The interval depends on the number of sensors in the system.
1211 in the second line indicates that the receiver is in a ‘jammed’ condition. Interference is at a level that prevents sensor transmissions from being received.
Issue
Can I mix Heat Detectors and 2 wire smokes with a sounder when using a D132A Smoke Detector Polarity Reversing Module?
Solution
No. When a Heat detector goes into alarm it puts a short on the input zone to indicate the alarm. The D132A uses Aux power from the panel when the polarity reversal takes place and since a heat detector does not reset when polarity is reversed, it would put a direct short on the Aux power of the panel. Consequently everything connected to the same Aux power terminals would not function.
How to prevent Users from Changing Codes on 2000 Series panels.
Pressing 5 to change codes is available to Owners and Users. How can Users be prevented from changing codes?
D2212,D2412,D2812
When attempting to use the Excursion mode feature on a 2000 series panel, why does the keypad prompt the user to enter a passcode after pressing the Clear key?
D2212,D2412,D2812
