How to configure the D4412 or D6412 for Point Expansion using RPS.
1. Program the D4412 or D6412 for using point doubling.
2. Address the DX2010 for point groups.
3. Select the EOL to be used with point groups.
The D4412 and D6412 use the D621, D623 or D625 command centers. Pressing All-On or Part-On on the will arm only the area where the keypad is assigned.
Command 50 may be used to move to an area other than the programmed assigned area. After moving to the selected area, press either All-on or Part-on to arm the area.
Command 80 may be used to arm all areas.
Command 81 may be used to disarm all areas.
Note: Commands 80 and/or 81 must be enabled by an individual with assigned authorization to perform the function.
Use Command 50 to move to another area and arm:
Press [CMD] [5][0] and enter a valid code if required.
The keypad will scroll through all available areas. Press the desired area number to move to the area.
Press All-On or Part-On to arm the selected area. Pressing and holding [CMD] will exit the Command 50 feature returning the keypad to its “home” area.
Use Command 80 to arm All Areas:
Press [CMD] [8][0] and enter a valid code if required.
Hold down the All On key for 2 sec and it forces all areas to All On.
Use Command 81 to disarm All Areas:
Press [CMD] [8][1] and enter a valid code if required.
The keypad will indicate all areas are off.
How to determine the max distance the DX3010 can be remote located from the control panel.
The maximum distance that the DX3010 can be remote located from the control panel is determined by whether or not an auxiliary power supply is used to power the DX3010.
How to determine the max distance the DX2010 can be remote located from the control panel.
This distance is determined by whether or not the DX2010 is supplying auxiliary power to devices. The DX2010 has the capacity to provide 12 VDC at up to 100 mA from the Aux Output terminals to power external devices such as motion detectors.
How to force Remote Programming Software (RPS) to connect to the panel from a keypad.
Remote Programming Software, Answer, 2000 series, D2212, D2412, D2812, D4412, D6412
How to correct Perimeter Instant Points going into Entry/Exit delay on the D4412 or D6412.
Why faulting a Perimeter Instant point may go into a delay countdown when the area is armed.
