Security: Intrusion

Issue Can I mix Heat Detectors and 2 wire smokes with a sounder when using a D132A Smoke Detector Polarity Reversing Module? Solution No. When a Heat detector goes into alarm it puts a short on the input zone to indicate the alarm. The D132A uses Aux power from the panel when the polarity reversal takes place and since a heat detector does not reset when polarity is reversed, it would put a direct short on the Aux power of the panel. Consequently everything connected to the same Aux power terminals would not function.

How to use the Line Monitor feature in Remote Programming Software.

How to Enable Alarm Verification and how it works.

Part numbers D7412, D9412, D7412G, D9412G, D7412GV2, D9412GV2, D7412GV3, D9412GV3, D7412GV4, D9412GV4, B6512, B8512G, B9512G, D9210, D9210B, D9210C, B901

How to correct the RS Control APP message:  "System is Disabled".

How to test the back-up phone line on the panel every 24 hours with the Primary Path setup as Ip communications. D9112, DX4020, B420, B426

Why do onboard points show missing when disabled in programming and are not used?

How to latch the Summary Fire Relay of a D7000/9000 and G Series control panel. Fire Summary Sustain

How to determine how long the loop wiring can be or how many devices can be connected to a D9127. D9127U,D9127T,D8125

How to use the Enter Key Relay function in G series panels.

How to correct the keypad response No RF Module when adding Inovonics RF Points.

How to interpret panel reports generated by MISSING Point Events on G Series Panels.

How to correct when the command center goes blank as soon as the last area arms. Why does the command center goes blank as soon as the last area arms?

How to prevent generating a Fail To Close when Perimeter Arming during the Closing Window. Why does the panel generate a Fail To Close after Perimeter Arming During Closing Window?