Security: Intrusion

Article describes C900V2 inputs and outputs

Article offers possible causes of no acknowledgement from C900V2.

How to configure a DX4020 for use with RPS.

How to reset the log-in password for the IP Communicator browser using Remote Programming Software.

While troubleshooting Conettix problems there are occasions when network traffic fails to pass on a particular port.  Determining whether or not the port is already in use, and therefore not available to the current configuration, is a valuable troubleshooting tool

Related Products B420 B426 DX4020 B3512 B4512 B5512 D7212 D7412 D9412 D7212G D7412G D9412G D7212GV2 D7412GV2 D9412GV2 D7212GV3 D7412GV3 D9412GV3 D7212GV4 D7412GV4 D9412GV4

Unable to direct-connect to a D9412 or D7412 control panel

How to connect to RPS with the modem connected directly to the Panel. How can I connect to a panel with a modem and only 1 phone line?

Describes possible cause of unable to arp into an older Netcom unit.

How to interpret the LED status of the B820 Inovonics wireless Interface module.

How to interpret the B901 or D9210c Access control interface module LED Status.

How to determine compatibility and address the B420 or B426 IP Communicator.

Related Products B426 Version

Pinout for crossover cable

This article describes the MAC addresses of the older network communication modules

How to test the back-up phone line on the panel every 24 hours with the Primary Path setup as Ip communications. D9112, DX4020, B420, B426

Creating a serial tunnel over the network to eliminate the need for long serial cables, or for connections to far for a serial cable to work.

How to correct the keypad response No RF Module when adding Inovonics RF Points.

This article details a possible cause to an ARP entry error message

How to determine the values to enter for the Poll Rate and Ack Wait Time. Note: The calculation described is only be required on legacy control panels.  The B8512G/B9512G and GV4 types only need a Receiver Supervision Time selection.  The Poll Rate, Ack Wait and Retry count will automatically populate.  The formula for determining Poll Rate and Ack Wait Time is as follows: Panel setting: Poll Rate + Ack Wait + ( Retry Count X Ack Wait) Receiver setting: Panel Poll + Ack Wait Panel setting = Receiver setting Example:    Panel Setting: Poll Rate = 240; Ack Wait = 10; Retry Count = 5 Panel setting: 240+10+ (5 X 10) = 300 Receiver Settings: Poll = 240; Ack = 60 Receiver setting: 240 + 60 = 300 300 = 300 Refer to the the following site for more information on setting up Conettix Devices www.conettix.com/Downloads.aspx