How to correct point 1 on a D4412 or D6412 will not restore even when using the programmed EOL.
Point 1 on the D4412 or D6412 will not restore even after strapping out with the EOL selected in Global Point Configuration.
The D4412 and D6412 use the D621, D623 or D625 command centers. Pressing All-On or Part-On on the will arm only the area where the keypad is assigned.
Command 50 may be used to move to an area other than the programmed assigned area. After moving to the selected area, press either All-on or Part-on to arm the area.
Command 80 may be used to arm all areas.
Command 81 may be used to disarm all areas.
Note: Commands 80 and/or 81 must be enabled by an individual with assigned authorization to perform the function.
Use Command 50 to move to another area and arm:
Press [CMD] [5][0] and enter a valid code if required.
The keypad will scroll through all available areas. Press the desired area number to move to the area.
Press All-On or Part-On to arm the selected area. Pressing and holding [CMD] will exit the Command 50 feature returning the keypad to its “home” area.
Use Command 80 to arm All Areas:
Press [CMD] [8][0] and enter a valid code if required.
Hold down the All On key for 2 sec and it forces all areas to All On.
Use Command 81 to disarm All Areas:
Press [CMD] [8][1] and enter a valid code if required.
The keypad will indicate all areas are off.
How to interpret Skeds 41 and above when only 40 schedules are available.
Why does the panel log file or central station report show skeds between 41 and 56 executed with only skeds 1-40 available in programming?
When attempting to use the Excursion mode feature on a 2000 series panel, why does the keypad prompt the user to enter a passcode after pressing the Clear key?
D2212,D2412,D2812
