Security: Intrusion

Describes using 2 readers on a D9210b or D9210c module.

How to test the back-up phone line on the panel every 24 hours with the Primary Path setup as Ip communications. D9112, DX4020, B420, B426

How to interpret the D8125Mux LED status and how to return the card to default. D8125 Mux, D5060

How to force Remote Programming Software (RPS) to connect to the panel from a keypad. Remote Programming Software, Answer, 2000 series, D2212, D2412, D2812, D4412, D6412

The reader sounds a constant tone and is wired correctly.

How to interpret wireless devices showing Missing in View Point Status.

How to correct the D1260 Command Center display: 'Incorrect Panel' that displays when properly programmed.

How to program  entry delay for motion detectors with a built in popit.

Part numbers D7212B, D9112B, D7212B1, D9112B1, D7212, D7412, D9112, D9124, D9412, D7412G, D9124G, D9412G, D7412GV2, D9124GV2, D9412GV2, D7412GV3, D9412GV3, D7412GV4, D9412GV4,

How to determine the values to enter for the Poll Rate and Ack Wait Time. Note: The calculation described is only be required on legacy control panels.  The B8512G/B9512G and GV4 types only need a Receiver Supervision Time selection.  The Poll Rate, Ack Wait and Retry count will automatically populate.  The formula for determining Poll Rate and Ack Wait Time is as follows: Panel setting: Poll Rate + Ack Wait + ( Retry Count X Ack Wait) Receiver setting: Panel Poll + Ack Wait Panel setting = Receiver setting Example:    Panel Setting: Poll Rate = 240; Ack Wait = 10; Retry Count = 5 Panel setting: 240+10+ (5 X 10) = 300 Receiver Settings: Poll = 240; Ack = 60 Receiver setting: 240 + 60 = 300 300 = 300 Refer to the the following site for more information on setting up Conettix Devices www.conettix.com/Downloads.aspx

How to Passcode Protect RPS Connection to the panel.

How to upgrade or downgrade GV3 Series panel firmware