How to interpret Missing Command 7 or Command 9.
Why are points 72 or 136 showing as MISSING in view point status?
Why are points 128 or 248 showing as MISSING in view point status?
D7212B,D7212B1,D9112B,D9112B1
Issue
User has authority in all areas but when presses Command 80, Command Center gives error tone and says Area 1 Ok for all on.
Solution
CMD 80 (All Areas On) and CMD 81 (All Areas Off) must be enabled in programming in order to function.
1) Using Remote Programming:
Go to Panel Wide Parameters; Global Open Close Options; Arming Options and find Enable Cmd 80 - All Areas All On, and Enable Cmd 81 - All Areas All Off and set both to Yes.
2) Using Keypad Programming:
Go to Nibble 1259 and enter 12 to enable both CMD 80 and CMD 81.
Part numbers D4412, D6412, D625, D623
Issue
How to setup the DS835 for application containing a pet.
Solution
1. Mount the detector 6.5ft (2M) high and set the PIR angle to -5 degrees.
2. Set the PIR sensitivity for Standard (STD).
3. Mount where the animals can not come within 6ft (1.8M) of the detector by climbing on furniture, boxes or other objects.
4. Do not remove the Look Down lens mask.
5. Do not aim the detector at stairways the animal can climb on.
6. Adjust the microwave range for the minimum acceptable coverage for the room in which the detector is installed.
Issue
Cannot access my menu items via the D1260 keypad, but know I the Menu Functions were enabled for the D1260 keypad within the panel program.
Solution
In programming
CMD CNTR ASSIGMENT > MENU KEY LOCK and set to NO.
Verify in programming FUNCTION LIST that the functions the required functions are set to Yes for the correct keypad address.
Compatible Control Panels • B9512G/B9512G-E • B8512G/B8512G-E • D9412GV4/D7412GV4/D7212GV41 • D9412GV3/D7412GV3/D7212GV31 • D9412GV2/D7412GV2/D7212GV21 • D9412G/D7412G/D7212G • D9412, D7412, D7212, and D9112 with firmware versions 6.40 or higher
Issue
Can I change the user text on a 7000-9000 series panel via the keypad?
Solution
You may only change the users name via a keypad if you have a D1260 keypad. Follow the steps below to make the changes.
>Command 56 then Passcode
>Choose the user number and press ENTER
>Press the soft key menu item CONTINUE
>Press the soft key menu item NAME
>Follow the soft key menu to move left/right and to change the characters in the name.
>After you done with the modifications press the soft key menu item CONTINUE
>If this is correct you press the soft key menu item YES
>If it is not correct then press the soft key menu item NO
After you have completed your task press the soft key menu item EXIT
D1260 Compatible Control Panels • B9512G/B9512G-E • B8512G/B8512G-E • D9412GV4/D7412GV4/D7212GV41 • D9412GV3/D7412GV3/D7212GV31 • D9412GV2/D7412GV2/D7212GV21 • D9412G/D7412G/D7212G • D9412, D7412, D7212, and D9112 with firmware versions 6.40 or higher
