How can the command center be cleared after an alarm condition on the 7000/9000 series panels?
D7412G,D9412G,D9412,D7412,D7212,D7212G,D9412GV2,D7412GV2,D7212GV2,D9412GV3,D7412GV3,D7212GV3,D9412GV4,D7412GV4,D7212GV4,D1255,D1260
How to control the Alarm Bell sound during Remote Arming or Keyswitch Arming.
The Alarm Bell is sounding when the area is armed remotely or by using a Keyswitch arm point. How can I prevent this?
The keypad is beeping every ten seconds for no apparent reason. The keypad is not displaying any troubles. How do I stop the keypad from beeping?
DS7400Xi,DS7400,DS7400XIVER2,DS7400XIVER3+,DS7400XIVER4+,DS7400X
The panel is dialing in Pulse when its programmed to dial in DTMF.
How to make the panel dial in DTMF when programmed for DTMF but still dialing in Pulse.
How do you change a code on the 9000/7000 series?
D7412G,D9412G,D9412,D7412G,D7412,D7212,D9412GV2,D7412GV2,D7212GV2,D9412GV3,D7412GV3,D7212GV3,D7412GV4,D9412GV4,D7212GV4
Definition:
Watch Mode Only- This point will not create alarm or trouble responses and will not generate reports to the Central Monitoring Station.
Program the Point: Select Point Type= 0. Select all Yes/No options= NO. Set Alarm Report Routing = 0: No Reports, No Events to Log/Printer. Set Restoral Report Routing = 0: No Reports, No Events to Log/Printer. Select Watch Tone and enable Watch Point: Select [Cmd] + 62 to select the watch tone. Select [Cmd] + 63 to select the watch point(s).
