Issue
The Panel will not arm by entering the PASSCODE, VERIFY ID, ALL ON/OFF.
Solution
On this panel for the ALL ON/OFF key to work CMD 1, CMD 2, and CMD 3 must be set to yes in the Arming Commands part of the program in the MAIN.
How to troubleshoot the panel only operating from Battery but not AC when a D928 is connected.
The panel is working but Command Centers read Service AC Fail. The A/C input voltage to the panel is correct but when the battery is removed the panel shuts down.
Overview
Remote Program (Key 2)
After pressing the [2] key and entering an Owner passcode to enter the Remote Program Mode, the display shows SYSTEM PROGRAM IN PROGRESS. If the [CLEAR] key is pressed to return to the OFF state, the system will not allow re-entering the Remote Program Mode for 30 seconds.
Issue
Remote Program (Key 2) and owners code will not work twice in a row.
Solution
D2212B Firmware Revision 3.03
After pressing the [2] key and entering an Owner passcode to enter the Remote Program Mode, the display shows SYSTEM PROGRAM IN PROGRESS.
If the [CLEAR] key is pressed to return to the OFF state, the system will not allow re-entering the Remote Program Mode for 30 seconds.
Issue
What would cause the Armed LED to not function on an LED Command Center, while arming the system?
Solution
To correct the Armed LED try the following steps:
1. Recycle power to the command center, and the panel.
2. Readdress the command center, anything other than address one. Then reprogram the command center for the same address number, and reset the panel.
Issue
What are the steps to start and end the phone session programming?
Solution
1. House Phone: Press the # key three times, and enter the passcode when prompted. Default ( 5432 )
2. Outside Phone: Dial the house phone number, and press * key three times when the call is answered, Enter a passcode when prompted
3. Installers Quick Connect: Connect a phone set to the control panel's test post. Press and hold the test button for approximately 15 seconds. Enter a passcode when prompted.
Note: To end the phone session, Press the # key repeatedly until the system says "goodbye".
Issue
Unable to use Command 00 function. When CMD 00 is entered, keypad reads 'SYSTEM COMMAND' or 'INVALID KEYS'.
Solution
Un-Bypassing points on the D7112 panel must be done by using the FUNCTION Menu. Access the Function menu by pressing 'Enter' at the idle disarmed text. Press Next repeatedly until Function Menu displays. To access the UNBYPASS screen press enter on Function menu and Next until UNBYPASS displays. Display will read ENTER POINT NUMBER, enter the point number to be bypassed and press Enter. Display will read the text for the point, press enter again and screen will read POINT UNBYPASSED.
Issue
Why is the green LED not lit on the 251 keypad?
Solution
The green LED monitors loop status, power supply, and the fuse on the panel. If the LED is shut off check all of the above. Note: zones are supervised with a 1K ohm resistor and 16.5VAC 20 VA transformer is used for AC power.
Point set up for relay follows point. Will the relay stop responding if the point is bypassed?
D9412,D7412,D7212,D9412G,D7412G,D7212G,D9412GV2,D7412GV2,D7212GV2,D9412GV3,D7412GV3,D7212GV3,D9412GV4,D7412GV4,D7212GV4,D7212B,D7212B1,D9112,D9112B,D9112B1
Issue
What are the steps on setting the panel time for the DS7100?
Solution
Enter in a valid master code # 0,7
Enter 01, then enter the time ( 24 hr. format ) then #
