Security: Access Control

Very often, it is easier to troubleshoot most AMS problems when logging is enabled. By default, this option is disabled in AMS. These steps will detail how to enable logging for AMS. Step-by-step guide  Log into the AMS server or client with administrative privileges 2     Click on the “Configuration” option\ 3     Next select the “Options” selection 4     Select the “Debug logfiles” option 5     Now check the “DMS, Terminal and MAC name” under the (Technicians) column. Leave the options under the (Support) column Unchecked unless specifically directed to. 6     In order for the logs to be available, the AMS server PC will need to be rebooted 7     After the AMS server is rebooted, reproduce the issue and it should now be listed in the log files for engineering to evaluate.    The log files are typically located in the C:\ProgramData\Bosch\Sicherheitssysteme\Access Management System\Logs

Check this article and find out if it is possible to connect AMC IP controllers together via RS485

This article can help with adding maps to a Security Escort system.

This article could be useful for you in case of AMS_RPS integration issues

This article contains how-to series about data migration from Access Professional Edition (APE) to Access Management System (AMS).

This article may be useful if migrating an Access Professional database to an AMS system

This article explains in a step by step guide how can you setup pincodes to work in AMS 4.0

When upgrading from a version 2.xx escort to a version 3.xx, one of the steps is to backup and restore a transponder.xml file.

This article contains the part numbers for the Security Escort licenses 

This article describes the use of the AECT utility within the AMS installation folder, that will check your PC specs to see if AMS can be installed. This is only a "guide" as to the recommended specs for installing AMS.

When trying to access the Access Easy Controller via Microsoft Edge, Chrome or other web browsers, you may get an error, "the connection for this site is not secure", which prevents you from connecting to the AEC.

This article provides you with the response to the question: "if I have a newer AEC firmware version, "2.1.9.x", can I downgrade it to 2.1.8.5?"

You would need to upload firmware 2.1.9.4 FIRST and then you can got to 2.1.9.5

When adding doors in AMS, the software will by default, assign each door strike relay based on the first available unused output on the controller.

See the 3 different part numbers of a Security Escort USB dongle, depending on what license you currently have or want to obtain.

This article contains the network ports that the Access Easy Controller (AEC) and Access Easy Master Controller (AEMC) use to communicate on the network.

This article presents what is the compatibility of the ARD-AYCE658 Reader with AEC 2.1.

This article explains what does a repeating low tone, high tone, and 1 sec pause mean on the AEC v. 2?

This article explains the message "Door already in use" from AECv2 when trying to delete a reader board

This article steps through the process of enabling the "pin or card" function in Access Professional Edition