Overview: Keypad displays a flashing "service perimeter" because a zone is or was faulted.
Issue
Keypad displays a flashing "Service Perimeter" with no zones displayed.
Solution
A Perimeter zone is or was faulted.
If a zone is displayed, the zone must be made normal first.
If no zone is displayed, enter CODE + ENTER + CLEAR + CLEAR . This will clear the keypad memory.
Issue
What is the process to set up auto arming on the DS7100?
Solution
To setup auto-arming perform the following steps:
Enter a valid master code # 0,7
Enter address 05, then the auto arm time in 24 hour format then #.
Example: Auto arm at 10:30 PM.
Master PIN + #0 ,7, 05, 2300 #
How is the Chime Mode enabled?
DS7060,DS7080I,DS7080IP32,DS7080IVER2,DS7090,DS7090I,DS7090TM,DS7090TMI,DS7100,DS7400,DS7400X,DS7400X,DS7400Xi,DS7400Xi (Ver 3+),DS7400Xi (Ver 4+),DS7400XIVER2
How to determine correct wiring with between the DS7420i and different DS7400 panel types.
Is the wiring configuration between the DS7420i and DS7400 panel different than with the DS7400Xi?
DS7400,DS7400X,DS7400Xi,DS7420i.
How to determine the wiring requirements for the multiplex bus and zone loops.
DS7400X,DS7400,DS7400Xi,DS7400XIVER2,DS7400XIVER3+,DS7400XIVER4+,DS7461i,DS7460i,DS7465i,DS7457i,DS7432
Issue
What are the proper steps to default a DS7100?
Solution
Enter program mode with a valid installers code #0 ( 98765 #0 ) is the default code. Or press and hold the S1 switch for 6 seconds.
Enter address 839#
Then press the S1 switch for 6 seconds.
Warning: Defaulting the DS7100 will erase all programming and user data in the system resulting in a system that needs to be reprogrammed.
Notice: This panal is equipped with Anti-Takeover Protection; all or part of the programmming may be locked so the program cannot be changed should someone attempt to take over the account.
The keypad is beeping every ten seconds for no apparent reason. The keypad is not displaying any troubles. How do I stop the keypad from beeping?
DS7400Xi,DS7400,DS7400XIVER2,DS7400XIVER3+,DS7400XIVER4+,DS7400X
Issue
Trouble connecting to the D4412 with RPS / RAM IV using the DX4010i.
What dip switches need to be set to make the DX4010i connect to the panel?
What type of cable is needed between the DX4010i and the Laptop or PC?
Solution
RAMIV / RPS needs to be revision 3.6 or higher.
Set the address 0 (Installer's mode) Dip Switches 6 and 8 in the off postion on the DX4010i.
Use a NULL cable to connect the DX4010i to the Laptop or PC.
For remote programming connection, use the RJ-16 to molex connector to the Aux / Data header.
Lock the Installer or Reset Pin on the panel.
In the RSP/ RAMIV Connection screen change the connection type from MODEM to ENHANCED DIRECT, then click connect.
*If connected to a D4412 panel and the address is set wrong on the DX4010i then a message of "INVALID RAM PASSCODE" may be generated.