Security: Intrusion

How to use the relay programming options in G Series Panels.

How to interpret the D8125Mux LED status and how to return the card to default. D8125 Mux, D5060

How to test the back-up phone line on the panel every 24 hours with the Primary Path setup as Ip communications. D9112, DX4020, B420, B426

How to force Remote Programming Software (RPS) to connect to the panel from a keypad. Remote Programming Software, Answer, 2000 series, D2212, D2412, D2812, D4412, D6412

The reader sounds a constant tone and is wired correctly.

How to interpret wireless devices showing Missing in View Point Status.

How to correct the D1260 Command Center display: 'Incorrect Panel' that displays when properly programmed.

How to program  entry delay for motion detectors with a built in popit.

How to set the supervision time for individual points.

How to work with Output Profiles. What are Triggers? Should Output Profiles be used in place of Area Wide or Panel Wide Outputs?  

How to determine the values to enter for the Poll Rate and Ack Wait Time. Note: The calculation described is only be required on legacy control panels.  The B8512G/B9512G and GV4 types only need a Receiver Supervision Time selection.  The Poll Rate, Ack Wait and Retry count will automatically populate.  The formula for determining Poll Rate and Ack Wait Time is as follows: Panel setting: Poll Rate + Ack Wait + ( Retry Count X Ack Wait) Receiver setting: Panel Poll + Ack Wait Panel setting = Receiver setting Example:    Panel Setting: Poll Rate = 240; Ack Wait = 10; Retry Count = 5 Panel setting: 240+10+ (5 X 10) = 300 Receiver Settings: Poll = 240; Ack = 60 Receiver setting: 240 + 60 = 300 300 = 300 Refer to the the following site for more information on setting up Conettix Devices www.conettix.com/Downloads.aspx

Part numbers D7212B, D9112B, D7212B1, D9112B1, D7212, D7412, D9112, D9124, D9412, D7412G, D9124G, D9412G, D7412GV2, D9124GV2, D9412GV2, D7412GV3, D9412GV3, D7412GV4, D9412GV4,

How to control the Alarm Bell sound during Remote Arming or Keyswitch Arming. The Alarm Bell is sounding when the area is armed remotely or by using a Keyswitch arm point. How can I prevent this?