Security: Intrusion

The reader sounds a constant tone and is wired correctly.

How to interpret wireless devices showing Missing in View Point Status.

How to set the supervision time for individual points.

How to correct the keypad response No RF Module when adding Inovonics RF Points.

How to determine how many EN4200 Receivers can be used with the B810.

This article details a possible cause to an ARP entry error message

How to determine the values to enter for the Poll Rate and Ack Wait Time. Note: The calculation described is only be required on legacy control panels.  The B8512G/B9512G and GV4 types only need a Receiver Supervision Time selection.  The Poll Rate, Ack Wait and Retry count will automatically populate.  The formula for determining Poll Rate and Ack Wait Time is as follows: Panel setting: Poll Rate + Ack Wait + ( Retry Count X Ack Wait) Receiver setting: Panel Poll + Ack Wait Panel setting = Receiver setting Example:    Panel Setting: Poll Rate = 240; Ack Wait = 10; Retry Count = 5 Panel setting: 240+10+ (5 X 10) = 300 Receiver Settings: Poll = 240; Ack = 60 Receiver setting: 240 + 60 = 300 300 = 300 Refer to the the following site for more information on setting up Conettix Devices www.conettix.com/Downloads.aspx

How to change Legacy Mode in the IP Communicator. Legacy Panel Mode cannot be changed with the B426 or B420 addressed to 0.

How to work with IP Communicator supervision in GV4 panels.

How to interpret the message Network Modx Cable Open.

How to correct the trouble: D9210 #x OPEN. What does it mean when the D1255 Keypad displays D9210 #1 OPEN?

How to enter an alternate MAC address into the D6686.

How to configure the D9210B, D9210C or B901 Access Control Module to require Access Granted to Enter and to Exit.