Issue
How do I clear alarm memory from the keypad?
Solution
On the D1260 keypad there are 4 buttons on the left and 4 buttons on the right side. Next to the bottom button on the right side should be a meesage that reads CLEAR DISPLAY.
1. Press the button beside the CLEAR DISPLAY prompt.
2. Enter your passcode.
3. Press the button beside the CLEAR prompt again.
Now alarm memory should be off the display on the keypad.
How to correct the D1255 Command Center going blank while selecting menus.
While entering key stroke commands and using the Menu option on the D1255, the display blanks out and the speaker crackles then the display comes up after 5 seconds.
How to correct custom functions that execute when A, B or C keys are pressed on the D720.
D1256 Command Center functions are Executing when A, B or C Keys on a D720 are pressed.
How to correct when the Independent Zone Controller point never restores to normal.
The panel point that uses a D279 or D279A never shows normal even though the Independent Zone Controller points are all normal.
D279A,D279
How can a SKED be disabled or changed from the keypad
D9412G,D7412G,D7212G,D1255,D1260,D7212,D7212B,D7212B1,D7412,D9112,D9112B,D9112B1,D9412D9412GV2,D9412GV3,D9412GV4,D7412GV2,D7412GV3,D7412GV4,D7212GV2,D7212GV3,D7212GV4
How can a SKED be disabled or changed?
D9412G,D7412G,D7212G,D1255,D1260,D7212,D7212B,D7212B1,D7412,D9112,D9112B,D9112B1,D9412,D9412GV2,D9412GV3D9412GV4,D7412GV2,D7412GV3,D7412GV4,D7212GV2,D7412GV3,D7412GV4
How to arm or disarm a single area using a keypad with scope in all areas.
When all areas are disarmed, associate areas can be armed independantly. But when attempting to disarm, associate areas keep rearming instead of disarming.
