Security: Intrusion

How to adjust the display on the D1260 Command Center. The The [99 + Enter “Setup?” Function] is no longer available in GV2 and higher control panels.

How to configure Swinger Shunt to prevent points from automatically bypassing after  only 1 alarm. Why does the panel zone generate 1 Alarm and then goes into Swinger Bypass? D4412,D6412,DS7220,DS7240

How to force Remote Programming Software (RPS) to connect to the panel from a keypad. Remote Programming Software, Answer, 2000 series, D2212, D2412, D2812, D4412, D6412

How to troubleshoot missing alarms on points connected to the D222A keypad. D2212, D2412, D2812, D222A.

The B8512 or B9512 supervises keypads even when disabled Related Products B8512 B9512 B915 B920 B921C B925F  B926F B930 B942    Overview   Issue The B8512 or B9512 supervises keypads even when Supervision=NO   Solution    If the keypad Type is set to an SDI type keypad (see below) the supervision setting can be configured YES or NO.  When the keypad Type is set to one of the SDI2 type keypads the supervision Yes/No setting is ignored and the keypad is supervised.   SDI2 devices are always supervised by design regardless of the supervision setting.   SDI Keypads  SDI2 Keypads  D1255 VFD Keypad (SDI)  B915  D125xRB Keypad (SDI)  B920  D126x LCD Keypad (SDI)  B921C    B925F    B926F    B930    B942 Notes SDI2 devices that are the same type of device must use different addresses. SDI2 devices that are not the same type can be configured to the same address.  For example: The B915, B92x, B930 or B942 are all same device types (keypads) and must use different addresses. The B920, B208 and B520 are all different device types and can all use the same address.

How to calibrate the D1265 keypad display.

  DS7400XIVER3+,DS7400X,DS7400XIVER2,DS7400XIVER4+,DS7447,DS7447I,DS7445,DS7447E

  How to View and clear Alarm Memory in the D6412 & D4412. D4412,D6412,D625,D623.  

Issue How do I clear alarm memory from the keypad?   Solution   On the D1260 keypad there are 4 buttons on the left and 4 buttons on the right side. Next to the bottom button on the right side should be a meesage that reads CLEAR DISPLAY. 1. Press the button beside the CLEAR DISPLAY prompt. 2. Enter your passcode. 3. Press the button beside the CLEAR prompt again. Now alarm memory should be off the display on the keypad.

How to troubleshoot why the D4412/D6412 keypad displays Not Ready regardless of all points normal. D623,D625

How to correct the D6412/D4412 keypad display: System Busy

How to troubleshoot the message "Keypad Disabled" on the D222 or D223 keypad.

   How to delete passcodes from the D4412 or D6412 using the D625 or D623 keypd. D623,D625,D6412,D4412.  

How to Troubleshoot the D4412/D6412 keypad says Not Programmed, See Install Guide.