How to configure Swinger Shunt to prevent points from automatically bypassing after only 1 alarm.
Why does the panel zone generate 1 Alarm and then goes into Swinger Bypass?
D4412,D6412,DS7220,DS7240
Keypad programming is available in GV3 panels with firmware revision 8.10 or higher.
NOTE: Keypad programming is not available during while an RPS programming session is active, or when any area is armed.
Enter from normal operation:
Press [9]+[9]+[Enter].
Select Keypad Programming. The keypad displays Enter Passcode.
Enter the service passcode (default= 123).
Enter from service mode (reset pin closed):
D1255:
Set the address to 16 with dipswitch: 1-5= OFF and 6= ON. The keypad displays Enter Passcode when the reset pin is closed.
Enter the service passcode (default= 123).
D1260:
Set the address to 8 with dipswitch: 1-3= OFF and 4-6= ON. The keypad displays Enter Passcode when the reset pin is closed.
Enter the service passcode (default= 123).
The following options are available upon entering keypad programming:
Phone Numbers – Phone 1 thru Phone 4
Phone Format - Phone 1 thru Phone 4
Enhanced Comm – Path 1 thru 4
Routing
Route Groups 1 thru 4
RPS Parameters
RPS Passcode
RPS Phone Number
RPS IP Address
RPS IP Port
Area Parameter – 1 thru 32
Account On – Yes / No
Account Number
Command Center 1 thru 16
Enhanced Command Center – Yes / No
Command Center Scope –
User Pass Code
User 0 (Install Passcode)
User 1 (User Passcode)
Point Parameters
D9412GV3: 1-247
D7412GV3: 1-75
D7212GV3 1 -40
Point Index
Disable Keypad Programming
Overview: User is entering passcode twice to arm alarm system. A five second delay between key strokes will cause the keypad to view the next entry as the start of a NEW passcode. Key strokes must be strung together with no pauses in between longer that 5 seconds.
Issue
User must enter passcode twice to arm the system. Same code is used for both entries.
Solution
The user is pausing too long between key strokes. After a key is pressed the next key stroke must be pressed wthin 5 seconds. A delay of 5 or more seconds will cause the keypad to view the next key stroke as the start of a new entry.
Where does the phone number information get entered in programming to instruct the end user to contact the security company when the help key is pressed on the D1260 keypad?
