Issue
How can I tell if the D168 will work with my control?
Solution
There are 3 items that are important when determining if it will be fully compatible with the control that is in question.
1. The control must provide a 12 volt dc aux power source to the D168A.
2. The control must have the ability to program a point as a keyswitch point. This only applies if you want to arm/disarm through the phone. Otherwise, you will just get arm/disarmed status. The keyswitch point can be programmed as momentary or maintained.
3. The control must have the ability to program a trigger that will trip and stay tripped when the system is armed.
Overview
Remote Program (Key 2)
After pressing the [2] key and entering an Owner passcode to enter the Remote Program Mode, the display shows SYSTEM PROGRAM IN PROGRESS. If the [CLEAR] key is pressed to return to the OFF state, the system will not allow re-entering the Remote Program Mode for 30 seconds.
Issue
Remote Program (Key 2) and owners code will not work twice in a row.
Solution
D2212B Firmware Revision 3.03
After pressing the [2] key and entering an Owner passcode to enter the Remote Program Mode, the display shows SYSTEM PROGRAM IN PROGRESS.
If the [CLEAR] key is pressed to return to the OFF state, the system will not allow re-entering the Remote Program Mode for 30 seconds.
How do you change a code on the 9000/7000 series?
D7412G,D9412G,D9412,D7412G,D7412,D7212,D9412GV2,D7412GV2,D7212GV2,D9412GV3,D7412GV3,D7212GV3,D7412GV4,D9412GV4,D7212GV4
When attempting to use the Excursion mode feature on a 2000 series panel, why does the keypad prompt the user to enter a passcode after pressing the Clear key?
D2212,D2412,D2812
The D4412 and D6412 use the D621, D623 or D625 command centers. Pressing All-On or Part-On on the will arm only the area where the keypad is assigned.
Command 50 may be used to move to an area other than the programmed assigned area. After moving to the selected area, press either All-on or Part-on to arm the area.
Command 80 may be used to arm all areas.
Command 81 may be used to disarm all areas.
Note: Commands 80 and/or 81 must be enabled by an individual with assigned authorization to perform the function.
Use Command 50 to move to another area and arm:
Press [CMD] [5][0] and enter a valid code if required.
The keypad will scroll through all available areas. Press the desired area number to move to the area.
Press All-On or Part-On to arm the selected area. Pressing and holding [CMD] will exit the Command 50 feature returning the keypad to its “home” area.
Use Command 80 to arm All Areas:
Press [CMD] [8][0] and enter a valid code if required.
Hold down the All On key for 2 sec and it forces all areas to All On.
Use Command 81 to disarm All Areas:
Press [CMD] [8][1] and enter a valid code if required.
The keypad will indicate all areas are off.
Issue
How is a code changed on the 251 arming station when used with a 3012 control/communicator?
Solution
Place J10 in lower enable position , then press blank key once, then enter old code once, new 4 digit code twice. Test new code by arming and disarming.
Issue
What would cause the Armed LED to not function on an LED Command Center, while arming the system?
Solution
To correct the Armed LED try the following steps:
1. Recycle power to the command center, and the panel.
2. Readdress the command center, anything other than address one. Then reprogram the command center for the same address number, and reset the panel.
