Security: Access Control

How can I allow a cardholder to have more than one active badge in the system

Article describes how to default the IP address of an AEC 1.0.

  Difference between the two different types of iClass keypad readers

Possible solution to getting AEC "permission denied" error

Article relates to the AMC Mux device.

Article describes how to configure rdkypro holidays

Article describes troubleshooting encryption error in rdkypro

  View Activity page on Access Easy Controller

Describes what the LpsSearch service is for.

Article gives possible reason for "door already in use" AEC error message.

This articles answers question if the 1320 inputs can be supervised.

This article will provide the workflow for adding an additional reader board to the primary RS-485 bus of an Access Easy Controller system.

Article describes what a specific AEC sound means

How is the Duress Alarm event generated in the Access Easy Controller?

License Manager is completely empty and BIS is in evaluation mode

Elevator Day Mode allows you to remove the need for badging so that you can allow open access to certain floors of a facility during the time periods you specify. Day Mode is configured on a per-floor basis, so the floors that need to remain in a secure state, requiring badging, can do so.

Articles describes AEC time and Attendance

Article describes how to setup the reader for pin codes.

Article describes how to enable rdkypro times anti-passback

  What causes the C900 VOLTAGE LOW and C900 VOLTAGE RESTORE messages at the D6600