How to interpret the panel executing Skeds 18-49 when only skeds 1-17are available.
D7212B,D9112B,D9112B1,D7212B1
Why does the panel show skeds between 18-49 executing when the panel only has skeds 1-17 available in programming?
How can I make Watch Mode not report to central station?
D9412G,D7412G,D7212G,D7212,D7412,D9112,D9412G, D9412GV2,D9412GV3,D9412GV4,D7412GV2, D7412G, D7412GV3, D7412GV4, D7212G, D7212GV2,D7212GV3,D7212GV4
How to determine correct wiring with between the DS7420i and different DS7400 panel types.
Is the wiring configuration between the DS7420i and DS7400 panel different than with the DS7400Xi?
DS7400,DS7400X,DS7400Xi,DS7420i.
How to determine the wiring requirements for the multiplex bus and zone loops.
DS7400X,DS7400,DS7400Xi,DS7400XIVER2,DS7400XIVER3+,DS7400XIVER4+,DS7461i,DS7460i,DS7465i,DS7457i,DS7432
How can a SKED be disabled or changed?
D9412G,D7412G,D7212G,D1255,D1260,D7212,D7212B,D7212B1,D7412,D9112,D9112B,D9112B1, D9412GV2,D9412GV3,D9412GV4,D7412GV2, D7412GV3
1. Ensure the area is disarmed.
2. Press Cmd + 4 + 2. The flashing Cmd light is a prompt to enter a valid passcode.
3. Enter a valid passcode and the D621 displays system trouble events by lighting the point indicators (zone leds)as described below:
Zone 1 Lit steady = Telephone line Fail
Zone 1 Slow Flash = Comm Fail, Destination 1
Zone 1 Fast Flash = Comm Fail, Destination 2
Zone 2 Lit steady = Alternate Comm Trouble
Zone 3 Lit steady = Installer Switch Closed
Zone 4 Lit steady = Backup Battery low
Zone 4 Lit steady = Slow Flash = Backup Battery Missing
Zone 5 Lit steady = Bell Supervision Fail
Zone 6 Lit steady = RF Receiver Jamming
Zone 6 Slow Flash = RF Receiver Trouble
Zone 7 Lit steady = Data Bus Device Missing
Zone 7 Slow Flash = Data Bus Device Tamper
Zone 7 Fast Flash = Data Buss Device Trouble/Reset
Zone 8 Lit steady = System Fault
Zone 8 Slow Flash = Service Interval
Zone 8 Fast Flash = Ground Fault Condition
Press Cmd to return to the off state.