Security: Intrusion

This Setup & Troubleshooting guide for the B426/B420 Conettix Ethernet Communication Module contains valuable instructions for configuring the IP Communicator.  Included are detailed instructions for using the web interface on SDI bus configurations as well as panel programming for SDI2 bus configurations.  Configurations for remote programming and central station reporting are also included.

How to prevent data noise, crosstalk, EMI, RFI and AC Inductance in data wiring.

How to change Legacy Mode in the IP Communicator. Legacy Panel Mode cannot be changed with the B426 or B420 addressed to 0.

How to reset the log-in password for the IP Communicator browser using Remote Programming Software.

How to determine compatibility and address the B420 or B426 IP Communicator.

This article describes the MAC addresses of the older network communication modules

How to determine how many network interfaces can be added to the control panel. B420 B426 DX4020

While troubleshooting Conettix problems there are occasions when network traffic fails to pass on a particular port.  Determining whether or not the port is already in use, and therefore not available to the current configuration, is a valuable troubleshooting tool

How to configure the DX4020 for Different Ports.

Creating a serial tunnel over the network to eliminate the need for long serial cables, or for connections to far for a serial cable to work.

Describes possible cause of unable to arp into an older Netcom unit.