Security: Intrusion

How to delay the scheduled Auto On Time of the D4412 or D6412.

How to power the D5060 multiplex programmer.

How to control the D8112 buzz when test reports are sent. The D8112 panel buzzes when it sends test reports, how can I stop the buzz? D8112G2,D8112E1,D8112G1,D8112A

Issue When attempting to connect to a DS7080iP-32 or DS7400Xi Ver4+ panel in WDSRP 2, Direct Connect does not appear as an option when Communicate is pressed. Solution WDSRP has not been set up to use Direct Connect function. Go to Utilities and Preferences, check Direct Serial Connect and press OK. Go back to Communicate screen and Direct Connect will appear.

   How to delete passcodes from the D4412 or D6412 using the D625 or D623 keypd. D623,D625,D6412,D4412.  

How to interpret the Alert Light flashing the DS7100 panel keypad after disarming. DS7140,DS7100.

How to interpret the panel executing Skeds 18-49 when only skeds 1-17are available. D7212B,D9112B,D9112B1,D7212B1 Why does the panel show skeds between 18-49 executing when the panel only has skeds 1-17 available in programming?

How to interpret the panel executing Skeds 41-56 when only skeds 1-40 are available. Why does the panel shows Skeds between 41 and 56 executed when only skeds 1-40 are available in programming?

How to program the D8112 panel to report AC Restoral Reports. Central Station Receiving AC Fail Reports but not AC Restoral Reports. D8112E1,D8112G1,D8112A,D8112G2.

How to interpret the two alternating asterisks (*) on the D8112 command center. D8112G2,D8112E1,D8112G1,D8112A

How to correct the correctly programmed D1260 displays 'CALL FOR SERVICE'. The D1260 displays CALL FOR SERVICE even though it is programmed correctly.  

How to determine D928 compatibility with D7212 panel types. After changing the setting "Two Phone Lines" to Yes then unlatching and relatching the Reset Pin, it is changed back to No. 

How to correct the D4412/D6412 only reporting to one destination and not following programmed routing.

 How to enable Open/Close Reports for Part On Modes. The panel sends Open/Close reports for All-On but not for Part-On.

How to correct point 1 on a D4412 or D6412 will not restore even when using the programmed EOL. Point 1 on the D4412 or D6412 will not restore even after strapping out with the EOL selected in Global Point Configuration. 

How to correct the Panel reporting Extra Points on Zones 1-8. The keypad is displaying trouble due to extra point on an onboard zone(1-8). 5800C,5800G,5900C,5900G

How to configure Swinger Shunt to prevent points from automatically bypassing after  only 1 alarm. Why does the panel zone generate 1 Alarm and then goes into Swinger Bypass? D4412,D6412,DS7220,DS7240

How to set the 4-button RF3334 RF Keyfob Trapazoid or Rising Sun key to activate an output.

How to correct the RS Control APP message:  "System is Disabled".

How to set the test report time on the 190 Test Report Timer module for the 4012/8012 panel. D4012,D8012