How to correct when the Independent Zone Controller point never restores to normal.
The panel point that uses a D279 or D279A never shows normal even though the Independent Zone Controller points are all normal.
D279A,D279
How to prevent Users from Changing Codes on 2000 Series panels.
Pressing 5 to change codes is available to Owners and Users. How can Users be prevented from changing codes?
D2212,D2412,D2812
I am able to arm the area with a 24 hour point violated in the same area. How can I prevent the area from being armed with a 24 Hour point violated?
24hour points do affect the 'ready to arm' status of the area, therefore will not prevent the ability to arm after clearing the alarm while the 24hour point remains faulted.
Program the 24 Hour Point as a Type 1, Response 9. When using point response 9, the point will operate as a 24hour point. However because this will become a controlled point it will prevent arming until either satisfied or bypassed (if the point is configured as bypassible).
How can a SKED be disabled or changed?
D9412G,D7412G,D7212G,D1255,D1260,D7212,D7212B,D7212B1,D7412,D9112,D9112B,D9112B1, D9412GV2,D9412GV3,D9412GV4,D7412GV2, D7412GV3
How can a SKED be disabled or changed from the keypad
D9412G,D7412G,D7212G,D1255,D1260,D7212,D7212B,D7212B1,D7412,D9112,D9112B,D9112B1,D9412D9412GV2,D9412GV3,D9412GV4,D7412GV2,D7412GV3,D7412GV4,D7212GV2,D7212GV3,D7212GV4
How to correct the Easy Series panel cannot arm the control panel as Occupied.
With an interior point faulted, you cannot arm the control panel as Occupied. The control panel indicates that the point is not ready to arm, and that it will bypass the point.
