Security: Access Control

  What causes the C900 VOLTAGE LOW and C900 VOLTAGE RESTORE messages at the D6600

License Manager is completely empty and BIS is in evaluation mode

Articles describes AEC time and Attendance

Elevator Day Mode allows you to remove the need for badging so that you can allow open access to certain floors of a facility during the time periods you specify. Day Mode is configured on a per-floor basis, so the floors that need to remain in a secure state, requiring badging, can do so.

This article discusses how to resolve an issue with missing programming buttons.

How is the Duress Alarm event generated in the Access Easy Controller?

Describes what the LpsSearch service is for.

This article provides you with the response to the question: "if I have a newer AEC firmware version, "2.1.9.x", can I downgrade it to 2.1.8.5?"

Article describes how to address devices on a LNL-8000

When adding doors in AMS, the software will by default, assign each door strike relay based on the first available unused output on the controller.

Article lists the location of the APE video Player

Article describes what "No Video Verification Active" means in APE.

Article describes how to setup the reader for pin codes.

Article describes ARD-AYCE65B and AEC compatibility.

Articles describes how to troubleshoot rdkyprosoftware connection errors

Article describes how to enable rdkypro times anti-passback

Below is a image which gives an overview of the AMC power supply consumption requirements: Typical IClass readers consume .78VA average and slightly over 1VA at maximum. The ARD-FPBEW2-H2 Bio Reader has an average of 7.2 VA average and almost 8VA maximum.

This articles answers question if the 1320 inputs can be supervised.

Article describes configuring escort "check-in"