Issue
Panel is not sending restorals when the point restores. Log also has no entries for restorals on the point.
Solution
This is normal if the panel is programmed not to send restorals.
In RAM/RPS check in the following: Point Index Codes > Point Indexes 1-16 or Point Indexes 17-31
Disable Restorals
Default: No Selections: Yes or No
Yes: Disable restoral reports for this point. No: Enable restoral reports for this point. When this option is enabled, a restoral report is sent to the receiver when the point returns to normal after being in an alarm or trouble condition.
If you are using the 5200:
In the 5200 check under:
9112B > Point Index > Point Index # (where # is a value between 1 and 31 only)
press the white ENTER key
press the down arrow key (red keys on the 5200)
Repeat until you are at P## Disable Restorals
Default: No Selection: Yes or No Yes = Disable Restoralreports for this point. No = Enable Restoralreports for this point. When this option is enabled, a Restoral report is sent to the receiver when the point returns to normal after being in an alarm or trouble condition. Use this item to automatically put this point back into the system.
Issue
When programming the D279 keypad point index on the 7000/9000, G, GV2, & GV3 series panels, how should the type and response be programmed?
Solution
Program a type 7 for D279 (O/C Non-Priority): The D279 provides point arming and disarming independent of the area arm state. A non-priority D279 point arm state does not affect the area arm state. Point Response must be programmed 1. Program type 8 for D279 (O/C Priority): The D279 provides point arming and disarming independent of the area arm state. A priority D279 point must be armed before an area can be armed. Program Point Response as 2.
How to use the D928 Dual Phone Module with PBX and Standard Phone Lines.
Can one of two phone lines be required to dial 9 for outside line (PBX) when the other (standard line) does not?
How to interpret the 'Check Device' display on a D1255 or D1260 keypad.
Why does the keypad display "Check Device"?
How to locate which point generated the 'Check Device' display and modify programming to prevent the display.
