Security: Intrusion

How to determine which GV4 panel types can be upgraded from ver 1.x to ver 2.x.

How to configure the DS7400Xi Ver4+ for Direct Connection using RS232. DS7400XIVER4+,DX4010i, DX4010V2

   How to delete passcodes from the D4412 or D6412 using the D625 or D623 keypd. D623,D625,D6412,D4412.  

How To Transmit Opening/Closing Reports By Account Number.

Describes how to print panel information.

How to program  entry delay for motion detectors with a built in popit.

Overview: In order to comply with SIA CP-01 standards, GV2 revision 7.06 and higher panels have modified the method that points programmed for Swinger Bypass are bypassed. GV2 panel revisions 7.05 and earlier will automatically bypass points and report Swinger Bypass P### when these points erroneously report four trouble or alarm events within one hour of the first event. RPS revision 5.5 and higher provides a field called Swinger Bypass Count to be used in GV2 panels revision 7.06 and higher. This setting, between 1 and 4, selects the number of times that a point will automatically bypass after going into trouble or alarm, the selected number of times, within 1 hour of the first event. The Swinger Bypass Count setting is defaulted to 1 and if left unchanged Swinger Bypass points will Bypass after one alarm or trouble event. Further, new GV2 panels revision 7.06 and higher come with a default Swinger Bypass Count setting of 1. If programming with RPS revision 5.4 or earlier, the Swinger Bypass Count field will not be available to change and the setting will remain at 1. Likewise, if programming with the D5200 programmer using GV2Aux revision 1.01 or 1.00 the same problem will occur. RPS 5.5 or GV2Aux revision 1.02 or higher is required for programming. Issue Why do points bypass after one trouble or alarm event? Solution The point that generated 1 trouble or alarm and Bypassed uses a Point Index with Swinger Bypass set to Yes and the Swinger Bypass Count is set to 1. This setting is modified in GV2Aux>Misc>Swinger Bypass count in RPS rev 5.5 or higher. Using a D5200 programmer, GV2Aux revision 1.02 must be used. Swinger Count can be modified by entering group on Miscellaneous and then Swinger Count.

How to set the supervision time for individual points.

How to Troubleshoot the D4412/D6412 keypad says Not Programmed, See Install Guide.

How to determine why the BFSK/Relay or Output selected in Point Assignments, or points configured with Relay Response=2, do not reset as expected.  

How to correct the unresponsive D8112 panel keypad with a Constant Buzz. 5505,D8112A,D8112E1,D8112G1,D8112G2

How to determine compatibility and address the B420 or B426 IP Communicator.

How to locate the Program Entry Guide for D2412 or D2812 panel types. D2412U, D2412UE, and D2812

How to use the B Series panel Battery supervision and Discharge - Recharge Schedule.

Program network reporting in GV3 version 8.10 and higher control panels.

How to configure the D4412 or D6412 for Point Expansion using Keypad Programming.

This article describes the MAC addresses of the older network communication modules