Security: Intrusion

Best practices to download and Install Remote Programming Software (RPS).

How to troubleshoot problems with popits and Zonex. D7212B, D7212B1, D9112, D9112B, D9112B1, D9127,D8112, D8128A, D8112B, D8128C, D8128D, D8125

Issue How to reset Smoke Detectors after an alarm. Overview: A D136 Plug in Relay is required see below. Solution Reset Detectors By using COMMAND 47, you are able to reset faulted detection devices such as smoke detectors, shock sensors or other power resettable devices from your Alpha II Command Center(Note: Ask your alarm technician which detection zones you may reset from the Alpha II by entering COMMAND 47). NOTE: If you enter COMMAND 47 and the detector resets momentarily, but then returns to a faulted condition, the detector may be faulty or still in an alarm mode. Contact your alarm company and describe the problem in detail. To use COMMAND 47: 1. Ensure security system is disarmed. 2. Press the COMMAND bar. The display should show "SYSTEM COMMAND". 3. Press and release the 4 key. Now press and release the 7 key. The display shows RESET SENSORS for approximately 10 seconds.   Part numbers D8112, D8112A, D8112E, D8112E1, D8112G, D8112G1, D8112G2  

How to lock access to the panel program to prevent take overs. D9112B1, D2012, D2112, D2212, D2412, D2812, D7212B, D7212B1, D8112G2L, D9112, D9112B, D9112B1

How to upgrade the D8112 and use existing Popit addresses and/or Popits.

How to convert Popit addresses from the D8112G2 to be used on a G-Series panel.

How to connect to RPS with the modem connected directly to the Panel. How can I connect to a panel with a modem and only 1 phone line?

How to set Popit dip switch addresses with the D8112.

How to transmit a manual test report from the D4112, D6112 or D8112.

This article has some possible solutions to the "subscript out of range" error in RPS.

Part numbers D8112, D8112E, D8112E1, D8112G, D8112G1, D8112G2

How to work with T-tapping POPIT Loops. D9127U,D8127T,D8125

How to force Remote Programming Software (RPS) to connect to the panel from a keypad. Remote Programming Software, Answer, 2000 series, D2212, D2412, D2812, D4412, D6412

Part numbers D8112, D8112E, D8112E1, D8112G, D8112G1, D8112G2

How to prevent data noise, crosstalk, EMI, RFI and AC Inductance in data wiring.

Issue What is the value for the EOL resistor used with a POPIT? Solution 33K Ohm 1/2 Watt EOL resistor on a POPIT. Ordering Part Number P106F

Part numbers D8112E, D8112E1, D8112G, D8112G1, D8112G2

Part numbers D8112, D8112A, D8112E, D8112E1, D8112G, D8112G1, D8112G2, D8105E, D8105E1, D8105G, D8105G1, D8105G2, D8105A