Issue
How is the battery test performed?
Solution
Type in (Command/ # ) 80 or a valid code # 80. If you want the sounder to trip with the battery test, type in #85.
If the Green power LED contiunes to flash after 10 seconds, the battery has failed and needs to be charged or replaced.
If the LED goes solid, the battery has passed.
Overview: User is entering passcode twice to arm alarm system. A five second delay between key strokes will cause the keypad to view the next entry as the start of a NEW passcode. Key strokes must be strung together with no pauses in between longer that 5 seconds.
Issue
User must enter passcode twice to arm the system. Same code is used for both entries.
Solution
The user is pausing too long between key strokes. After a key is pressed the next key stroke must be pressed wthin 5 seconds. A delay of 5 or more seconds will cause the keypad to view the next key stroke as the start of a new entry.
Issue
The D5200 programmer has only 128K RAM, how can it be expanded to 512K?
Solution
The D5215 is a memory circuit board that installs on the main board inside the D5200 programmer. This provides the A drive with an additional 384K of RAM which then brings the total A drive compacity to 512K.
Part numbers D5200, D5215
How to use the D928 Dual Phone Module with PBX and Standard Phone Lines.
Can one of two phone lines be required to dial 9 for outside line (PBX) when the other (standard line) does not?
Where does the phone number information get entered in programming to instruct the end user to contact the security company when the help key is pressed on the D1260 keypad?
How to progrma the 6112/5503 to send reboot reports.
6112/5503panel is communicating alarm and trouble signals but, when I do a disable restart it will not send the reboot signal.
