Security: Intrusion

How to test the back-up phone line on the panel every 24 hours with the Primary Path setup as Ip communications. D9112, DX4020, B420, B426

The Remote Security Certificate Builder panel list is empty Related Products Remote Security Certificate Builder

How to force Remote Programming Software (RPS) to connect to the panel from a keypad. Remote Programming Software, Answer, 2000 series, D2212, D2412, D2812, D4412, D6412

The reader sounds a constant tone and is wired correctly.

How to program  entry delay for motion detectors with a built in popit.

How to set the supervision time for individual points.

How to correct the keypad response No RF Module when adding Inovonics RF Points.

How to work with Output Profiles. What are Triggers? Should Output Profiles be used in place of Area Wide or Panel Wide Outputs?  

How to determine the values to enter for the Poll Rate and Ack Wait Time. Note: The calculation described is only be required on legacy control panels.  The B8512G/B9512G and GV4 types only need a Receiver Supervision Time selection.  The Poll Rate, Ack Wait and Retry count will automatically populate.  The formula for determining Poll Rate and Ack Wait Time is as follows: Panel setting: Poll Rate + Ack Wait + ( Retry Count X Ack Wait) Receiver setting: Panel Poll + Ack Wait Panel setting = Receiver setting Example:    Panel Setting: Poll Rate = 240; Ack Wait = 10; Retry Count = 5 Panel setting: 240+10+ (5 X 10) = 300 Receiver Settings: Poll = 240; Ack = 60 Receiver setting: 240 + 60 = 300 300 = 300 Refer to the the following site for more information on setting up Conettix Devices www.conettix.com/Downloads.aspx

How to change Legacy Mode in the IP Communicator. Legacy Panel Mode cannot be changed with the B426 or B420 addressed to 0.

How to control the Alarm Bell sound during Remote Arming or Keyswitch Arming. The Alarm Bell is sounding when the area is armed remotely or by using a Keyswitch arm point. How can I prevent this?

How to interpret the message Network Modx Cable Open.

How to Passcode Protect RPS Connection to the panel.

How to configure the D9210B, D9210C or B901 Access Control Module to require Access Granted to Enter and to Exit.

How to program control panels for Daylight Savings Time.

How to configure a point to disarm one or more areas but not re-arm if tripped again to be used on B8512G, B9512G and B-Series panel types.

How to test Inovonics wireless motion detectors using CMD 44Walk Test.

How to interpret the Comm Trouble SDIxx or Comm Fail SDIxx display.

How to restore the B42x card back to default values?

How to determine which B942 credentials will also work G series access doors?