I am able to arm the area with a 24 hour point violated in the same area. How can I prevent the area from being armed with a 24 Hour point violated?
24hour points do affect the 'ready to arm' status of the area, therefore will not prevent the ability to arm after clearing the alarm while the 24hour point remains faulted.
Program the 24 Hour Point as a Type 1, Response 9. When using point response 9, the point will operate as a 24hour point. However because this will become a controlled point it will prevent arming until either satisfied or bypassed (if the point is configured as bypassible).
How can a SKED be disabled or changed from the keypad
D9412G,D7412G,D7212G,D1255,D1260,D7212,D7212B,D7212B1,D7412,D9112,D9112B,D9112B1,D9412D9412GV2,D9412GV3,D9412GV4,D7412GV2,D7412GV3,D7412GV4,D7212GV2,D7212GV3,D7212GV4
How can a SKED be disabled or changed?
D9412G,D7412G,D7212G,D1255,D1260,D7212,D7212B,D7212B1,D7412,D9112,D9112B,D9112B1,D9412,D9412GV2,D9412GV3D9412GV4,D7412GV2,D7412GV3,D7412GV4,D7212GV2,D7412GV3,D7412GV4
How to lock access to the panel program to prevent take overs.
D9112B1, D2012, D2112, D2212, D2412, D2812, D7212B, D7212B1, D8112G2L, D9112, D9112B, D9112B1
How to correct point and user numbers reporting in a non-standard format, example; points 1-9 reporting as 101-109 or users 006-013 reporting as 601-608.
How to arm or disarm a single area using a keypad with scope in all areas.
When all areas are disarmed, associate areas can be armed independantly. But when attempting to disarm, associate areas keep rearming instead of disarming.
