Security: Intrusion

This article has some possible solutions to the "subscript out of range" error in RPS.

How to change the site code of a D8229 Access Keypad 

How to force Remote Programming Software (RPS) to connect to the panel from a keypad. Remote Programming Software, Answer, 2000 series, D2212, D2412, D2812, D4412, D6412

How to determine the values to enter for the Poll Rate and Ack Wait Time. Note: The calculation described is only be required on legacy control panels.  The B8512G/B9512G and GV4 types only need a Receiver Supervision Time selection.  The Poll Rate, Ack Wait and Retry count will automatically populate.  The formula for determining Poll Rate and Ack Wait Time is as follows: Panel setting: Poll Rate + Ack Wait + ( Retry Count X Ack Wait) Receiver setting: Panel Poll + Ack Wait Panel setting = Receiver setting Example:    Panel Setting: Poll Rate = 240; Ack Wait = 10; Retry Count = 5 Panel setting: 240+10+ (5 X 10) = 300 Receiver Settings: Poll = 240; Ack = 60 Receiver setting: 240 + 60 = 300 300 = 300 Refer to the the following site for more information on setting up Conettix Devices www.conettix.com/Downloads.aspx

How to create a Man-Trap in a G-Series or B6512 Intrusion Panel. How to block use of an access credential if another door is opened.

The B8512 or B9512 supervises keypads even when Supervision=NO Related Products B8512 B9512 B915 B920 B921C B925F  B926F B930 B942

Issue The keypad displays the Access Module Door Point is in trouble. Diagnostics displays the point as missing. Solution T+ (Tamper Input) of the Access Module is an unsupervised input that is normal when open. Upon a short, the Door Point number assigned to the supervised zone of the Access Module is reported as a MISSING PT###.

How to use the Auto Door function with access doors in G Series panels.

How to use the relay programming options in G Series Panels.

How to arm only the area the keypad is assigned to rather than all of the areas it can see.

How to test Inovonics wireless motion detectors using CMD 44Walk Test.

How to configure door control with multiple Users and Doors Part II.

How to prevent data noise, crosstalk, EMI, RFI and AC Inductance in data wiring.

How to decypher 'Device Trouble SDI - 0408 on a B-Series Panel

How to address and where to connect the DX4010V2 or DX4010i.

Issue What is the value for the EOL resistor used with a POPIT? Solution 33K Ohm 1/2 Watt EOL resistor on a POPIT. Ordering Part Number P106F