Security: Video

This article contains the RCP+ commands (VJD 7513) to change the layout and see what camera you want to be displayed

This article contains the CGI commands that help you to enable or disable the MIC 7100i/MIC 7000i/MIC fusion 9000i camera's Wiper during boot-up

The RCP documentation can be found in the Firmware .zip file on the product page.

Using the following command you can reset the result of People counting via SDK: http://<IP_address>/rcp.xml?command=0x0b4a&type=P_OCTET&direction=WRITE&num=1

Are you looking for the MIC IP fusion 9000i Wiper/Washer RCP command syntax to incorporate it in the third party software?

If you are using the ATSL-script, use the following RCP-CGI command to switch ON-OFF the IR-LED of FLEXIDOME IP 3000i IR camera

First recommendation would be to configure the mode for IVA as a trigger, setting IVA as Profile 1 for “trigger off” and IVA as silent for “trigger on”.

You can call desired pre-positions (PTZ) of Bosch IP cameras by using OSRD protocol or BiCom protocol. Please check this aticle to find some examples and detailed explanation.