Bosch Building Technologies

    Showing results for 
    Search instead for 
    Did you mean: 
    Sort by:
    2 weeks ago
    The camera supports 802.3at type 2 class 4 and 802.3bt type 3 class 5 standards. It is an IEEE802.3bt compliant device but also compatibele with 802.3at/af compatible devices. However, please note that some midspans are not compatible
    View full article
    ‎04-12-2023 02:30 PM
    This article provides causes and solutions regarding Netapp E2800 periodically disconnections.
    View full article
    100% helpful (1/1)
    ‎03-20-2023 09:55 AM
    When the camera operates in automatic Night-Mode and the switching interval is too fast the camera built in protection mechanism will intervene to prevent premature wear of the mechanical IR-Cut filter.
    View full article
    ‎03-14-2023 04:09 PM
    Upon powering on the DIVAR IP all-in-one 7000 system you hear FAN spinning normal, LEDs are blinking at normal frequency and there are no error beep codes. However, there is no display when connected via VGA (or) DVI (or) DP. Check out this article and find out how to fix this!
    View full article
    ‎02-06-2023 10:25 AM
    This is a known design limitation and has always been present in the mentioned platforms. There are also no plans to correct this behavior.
    View full article
    ‎01-24-2023 11:53 AM
    This account has been locked because of too many failed login attempts. Try again in 39 seconds.
    View full article
    ‎11-09-2022 03:44 PM
    This article provides solutions regarding how to resolve SD Card Recording Issues with the MIC-7100i IP starlight and Inteox Cameras
    View full article
    ‎10-26-2022 10:10 AM
    This article presents solution regarding how to stop "rtp.p_type 97" (OSD or Video Authetication packet) on a CPP4 and CPP7.3  
    View full article
    ‎08-03-2022 03:44 PM
    This is happening across several platforms and is happening in CM not on the Web. The behavior was observed on CM 7.50.0073
    View full article
    ‎06-14-2022 03:43 PM
    This article helps you to find a solution for your MIC IP ultra 7100i (CPP 7.3 ) when front end is not available after FW upgrade from 7.62.0005 to 7.70.0126
    View full article
    ‎05-20-2022 09:39 AM
    Before asking for assistance, please collect and provide the Central Technical Support Team with the information from this article.
    View full article
    Top Contributors