Security: Video

This is a step-by-step guide about how to collect BMC logs (RAID & IPMI Event Logs, System, Audit & Video Logs) of DIP AIO 7000 gen4.

VideoView+ for DIVAR IP allows you to remotely monitor video footage from cameras connected to your DIVAR IP. It’s ideal for multi-site facilities, from mid-to-larger quantities of cameras per site, in need of local high-retention time, or RAID recording requirements. This is compatible with DIVAR IP all-in-one 4000, 5000, 6000, and 7000. To use the VideoView+ online service, you must first have an account on Remote Portal.

The ASUS Inband Tool is the preferred log collection tool, all relevant logs can be gathered from there for ASUS Tech Support. LSI Storage Authority, LSA for short, can be found on the DIP74xx’s Windows desktop. 

This article presents the comprehensive steps of DIVAR-IP all-in-one System Manager and Remote System Management installation and configuration

This article shows where to find the BIOS default password of DIVAR IP all-in-one 7000 gen4 (DIP-74xx).

In this article is explained step by step how to collect System Manager logs from your DIVAR IP all-in-one 4000 & 6000.

A red LED will be displayed in front of the damaged HDD. On DIP-74xx with RAID5, with only one faulty HDD, there is no DATA LOSS.

The following instruction describes how to create a RAID5 logical volume on the DIVAR IP all-in-one 7000 4th gen. This procedure will wipe the current logical volume and therefore cause DATA LOSS.

With the release of the DIVAR IP all-in-one 7000 gen4 (DIP-74xx), a new tool is available for health monitoring and log gathering, it essentially replaces SuperMicro’s SuperDoctor5; the ASUS Inband Tool. This tool operates as a service on the DIP and provides a webpage with hardware health monitoring options, hardware status details, and hardware information, as well as an option to export logs and run reports.

The following instruction describes how to configure a data partition from RAID 5 to RAID 6 on the DIVAR IP all-in-one 7000 4th generation. It is not possible to directly migrate from RAID 5 to RAID 6, so the first step is to delete RAID 5 and then create RAID 6.

By default, the DIVAR IP all-in-one 7000 devices are intended to operate with one or two local monitors, connected to HDMI interfaces on the rear of the unit. If NO HDMI is connected, then iKVM over BMC port is active and available. In this case, it is supported to remove VGA cover and use it as local admin monitor, not to run the Operator Client.

This article is a step-by-step guide about how to update the BIOS on the DIVAR IP all-in-one 7000 4th gen (DIP-74xx).