Security: Video

Find out from this article the cause and possible solutions for status 4 and status 6 messages occurred on MIC IP FUSION 9000i camera.

This article it is about analog control system connected directly to the MIC IP serial port. The serial com ports of traditional analog systems head end control systems connect directly to the RS485 input of the MIC IP models listed within this article.

If  ‘Calibration upload to camera failed’ for CPP7.3 & CPP13 Bosch cameras please follow the below steps: Upgrade Configuration Manager to version 7.61. This must be used in combination with CPP13 Firmware 8.45 or later  

This article contains the CGI commands that help you to enable or disable the MIC 7100i/MIC 7000i/MIC fusion 9000i camera's Wiper during boot-up

The MIC IP fusion 9000i supports only simplified Chinese language. There is no option to select traditional Chinese in the menu.

Check out this article and find out the streaming capabilities of CPP7 & CPP7.3 Bosch IP cameras

This article provides a solution to the intermittent focus issues for MIC 7000i series and for the Optical video in the MIC 9000i

All of camera block FW updates require an additional step for the FW upgrade process, which is described in the documents attached.

This article explains how to fix the behavior of MIC IP 7000i/9000i Bosch camera when is out of focus during a rapid zoom

See what you can do when MIC 7000i with FW 7.72 shows blurred images. After restart, the quality of the image is good for a short time, but the issue reappear.

Are you looking for the MIC IP fusion 9000i Wiper/Washer RCP command syntax to incorporate it in the third party software?