Find out from this article what to do when the Decoder VJD-7513 with FW 10.31.0005 is displayed in BVMS but: First monitor connected on HDMI to HDMI on monitor shows images. Second monitor connected via a USB-C-to-DP cable to the DP port on the monitor shows no output on the second monitor.
Monitor Group gives operators flexible control over the content of a video wall or allows them to let the system take over this control automatically based on pre-defined scenarios. This article describes how to create a Monitor Group on a decoder VJD 7xxx/ 8xxx in BVMS Configuration Client
From this article you will find out how to set up the IP Matrix configuration on the VIDEOJET decoder 7000 (VJD-7513) using Configuration Manager.
The built-in IP Matrix functionality, together with a connected keyboard, allows VIDEOJET decoder 7000 to run as a stand-alone system.
An operator can manage up to 32 cameras via the keyboard without any PC or management system required. System setup is quickly done with Configuration Manager. After that, no PC is required to run the IP Matrix
According to the Release letter (Firmware 9.51) of VJD-7513, VIDEOJET decoder 7000 supports IP Matrix application as built-in feature.
According to the Release letter (Firmware 54.8.02) of VJD-7000, IP matrix remote monitor is only possible with UDP. TCP not supported.
** VJD-7000 can be used as an extended monitor to IP Matrix in single and quad view.
Please check also the following article and find out: Which are the system requirements for configuration/ operation of VIDEOJET decoder 3000/ 7000/ 8000?
A single system can support:
2 physical monitor displays
One KBD-Universal XF keyboard
32 camera sequences
9 favorite views
If you add a decoder that has 2 monitors connected, you must display the Edit Decoder dialog box of the decoder and update the device capabilities of this decoder. For each monitor add a further monitor wall.
Can I display more than 1 camera on a single Monitor of Decoder VJD-7513 in BVMS 11.0 when an alarm is triggered?
1 monitor connected to 1 x VJD-7513 that is part of a Monitor Group
The monitor has a layout consisting of several image panes
Desired status: when an alarm is triggered → pop up the image of the 4 cameras on the same decoder monitor
Before you can operate your VIDEOJET decoder 7000/ 8000 within your network, it must have a valid IP address for your network and a compatible subnet mask.
This articles explains how you can change the IP Address of VIDEOJET decoder 7000/ 8000 using Configuration Manager.
If you have the option "Extended (security)/configuration mode" active on a VIDEOJET decoder 7000 (VJD-7513) in Configuration Manager, then no video image will be shown and the BOSCH logo will be displayed at the cameo of the monitor output of the decoder.
This is as designed in Configuration Manager, and this mode is to give you the opportunity to enable the SSD Encryption and to disable the USB ports.
Once you are finished changing the extended security features, you must uncheck the check box and the decoder will go back to normal functioning.