This website uses absolutely necessary cookies. If you consent to the use of convenience cookies, please click “Yes, I agree.” By clicking on “Privacy Settings.” you can change this setting at any time and withdraw your given consent.
You can find detailled information in
Decide which cookies you want to allow. You can change these settings at any time. However, this can result in some functions no longer being available. For information on deleting the cookies, please consult your browser’s help function.
Decide which cookies you want to allow.
You can change these settings at any time. However, this can result in some functions no longer being available. For information on deleting the cookies, please consult your browser’s help function.
This article describes how to factory default a DIVAR IP 5000 Unit
The DIVAR IP 5000 does not come with a internal DOM for recovery, but with SSD media inside with relevant recover partition used during new recovery process.
The Reset Button is used for two options of Recovering the unit - see installation Manual page 25 - chapter 8.2. The button is located on the lower left hand side of the appliances rear connection panel. This button is utilized in both reset procedures. The following order need to be kept and the manual corrected:
Defaulting Video Recording Manager (VRM)
To default an appliances previously configured VRM, with the appliance powered on and functioning.
Press and hold the reset button for 10 seconds
Then the VRM database will be set to factory default; No recordings will be removed from the unit; And IP addressing will remain, as well as any modifications to the operating system (time settings etc.)
Factory Defaulting the Appliance
Power the appliance completely off.
Apply power, and only after LED activity is seen on the front of the appliance, press and hold the reset button.
After a few seconds an audible “beep” should be heard. This is a signal that the internal watch dog has acknowledged the reset request. Release the reset button
When the reimage process is finished the appliance will reboot. After reboot users can use the IPHelper.exe to connect to the appliance’s Configuration Wizard or use the Configuration Manager to monitor when the DIVAR IP 5000 comes back online.