Security: Video

This article presents which are the new features in Video Security 3.4 for Windows, Android and iOS.

This article describes how to set LUNs on a target to Read Only via Configuration Manager.

This article shows how to reset the Sony Ipela HD (SNC-DH180) camera to the factory default settings.

This article contains different Q&A regarding the Camera certificate in Config. Manager & WEB GUI: size limit, supported formats and limitations.

DIVAR network 5000 / DIVAR hybrid 5000   support configuration of 3rd party cameras through the ONVIF Profile S protocol.

Follow this article and find out how to store a snapshot of all cameras automatically from the Operator Client

If the IPMI default password is lost, a tool called IPMICFG-Win, available from the SuperMicro website, can be used to recover it.

Monitor Group gives operators flexible control over the content of a video wall or allows them to let the system take over this control automatically based on pre-defined scenarios. This article describes how to create a Monitor Group on a decoder VJD 7xxx/ 8xxx in BVMS Configuration Client

This article describes the steps that are required to access the DIVAR IP 5000 AIO system from the internet.

Before you can operate your VIDEOJET decoder 7000/ 8000 within your network, it must have a valid IP address for your network and a compatible subnet mask. This articles explains how you can change the IP Address of VIDEOJET decoder 7000/ 8000 using Configuration Manager.

This article it is about analog control system connected directly to the MIC IP serial port. The serial com ports of traditional analog systems head end control systems connect directly to the RS485 input of the MIC IP models listed within this article.

This article presents possible causes and solution regarding no recording for cameras added to VRM (DIP 7000AIO): ‘Unexpected error’ in BVMS Config Client

Find out from this article where you can find the installation code needed to license a Bosch camera

This article describes the considerations that need to be taken into account when designing a video surveillance system that is suitable for person identification. 

This article explains how to playback the SD card recordings in Operator Client from a camera added as Local Storage in BVMS Lite 10.1

Time zone drop down is greyed out and it's not possible to reconfigure the Time Zone on the DIP-44/64 after installing BVMS 12.1 and enabling UAC.

Alarm functions include local inputs and relay outputs, plus motion detection in user-defined areas. If an alarm is detected, the DIVAR can: send an e-mail notification and/or FTP push, sound a buzzer and/or display a warning, activate local alarm output

This article explains how to integrate the Bosch MIC IP 7000 HD camera series into any existing analog CCTV system using the Bosch VIDEOJET decoder 3000. The most common integration scenarios are listed below: Simple integration using direct connectivity to analog monitor and joystick, typically found in single camera installation (for example, mobile surveillance vehicles) Integration into an existing analog matrix switcher typically found in large installations (such as for city surveillance)

Short intro and related topics: This article will review the settings required to configure Windows as a NTP time server. Note: If you are running VRM and have the Time Server enabled, you must disable the Time Server before performing the following. Article requirements: Windows Server 2016/ Windows 10