Related Products Bosch Recording Station Video Jet X Series BRS Question Is it possible to control an AutoDome connected to VideoJet X Series via Bilinx? Answer In BRS 8.8.1 Bilinx over Encoder only works for devices connected via VSDKPluginModule. Current supported devices are VIP-X1600-XFM4B and VIP-X1XF. VideoJet X series are connected per default via VCSModule, which does not support Bilinx communication. To be able to control Bilinx devices on VideoJet X series please configure the following work around: 1. In BRS Configuration > IP Cameras and encoders > Scan network (VideoJetX is found) and add VideoJetX device to BRS 2. Click VideoJetX and click Edit 3. In tab General settings select Device Type BVIP H.264 4. In tab Dome settings mark Activate and select Connection Bilinx/IP Dome Now the AutoDome can be controlled via Bilinx. Note: Due to performance reasons do not change the encoder stream from MPEG-4 SH++ to H.264 streaming! Only change the device type in BRS.
Related Products DiBos version 8.0 to 8.7 BRS version 8.8 and later Question How to configure LDAP in DiBos / BRS? Answer See attached 8 screenshots which guide through the LDAP configuration. Known restrictions on the AD: - users and user groups must be located in the same directory in the AD - DiBos / BRS supports max. 1000 user groups in the AD - Comma separated user (ex. User, John) are not supported.
Related Products Bosch Recording Station (BRS) version 8.9 and later Question I cannot configure UDP tunneling on BRS. Network cards are grayed out. Answer Under certain circumstances BRS NetLimiter may become not registered. The network cards are not shown in Configuration > Security and Network > Network settings. In that case, register BRS NetLimiter manually: 1. Close BRS application 2. Control Panel > System and Security > Administrative Tools > Services > Bosch Networking Service a) Set "Startup Type" to "disabled" b) Stop service c) In a console window with administrative rights, enter "C:\Program Files\Bosch\Recording Station\NetLimiterServer" /service d) Set "Startup Type" to "Automatic" e) Start service 3. Start BRS application