Security: Video

Yes. Since the system does not have a valid SMA, the Central Technical Support team cannot perform the license transfer from one unit to the other.

This article is a step-by-step guide about how to update the BIOS on the DIVAR IP all-in-one 7000 4th gen (DIP-74xx).

Equipment should be mounted into a rack so that a hazardous condition does not arise due to uneven mechanical loading.

This article shows where to find the BIOS default password of DIVAR IP all-in-one 7000 gen4 (DIP-74xx).

By default, the DIVAR IP all-in-one 7000 devices are intended to operate with one or two local monitors, connected to HDMI interfaces on the rear of the unit. If NO HDMI is connected, then iKVM over BMC port is active and available. In this case, it is supported to remove VGA cover and use it as local admin monitor, not to run the Operator Client.

According to the DIP Whitepaper, the unit supported 128 channels before upgrading. After upgrade to BVMS >= 11.0, having the MBV-BPLU-DIP base, the channels licenses limit is 256 channels 

This article explains which is the difference between BVRAdmin lost password versus VRM lost password (reset) of DIVAR IP.

The ASUS Inband Tool is the preferred log collection tool, all relevant logs can be gathered from there for ASUS Tech Support. LSI Storage Authority, LSA for short, can be found on the DIP74xx’s Windows desktop. 

Limited user is available on DIVAR IP all-in-one 4000, if the unit has HDDs inside. Every setup with DIVAR IP System Manager, on any DIP (AIO 7000 GEN 3, AIO 4000, AIO 5000, AIO 6000) that is "00N" (without HDDs) will fail and result in a lack of a "limited user" and "kiosk mode", if you do not insert the HDDs and perform the necessary steps from the manual.

This article explains if is it possible to enable Remote Desktop on DIVAR IP all-in-one 6000 and connect on it remotely.

The following instruction describes how to configure a data partition from RAID 5 to RAID 6 on the DIVAR IP all-in-one 7000 4th generation. It is not possible to directly migrate from RAID 5 to RAID 6, so the first step is to delete RAID 5 and then create RAID 6.