Security: Video

The alarms appear, the forensic search is working fine, but the yellow lines don’t appear on the recording line/ timeline. What to do to display the yellow lines in timeline?

All of camera block FW updates require an additional step for the FW upgrade process, which is described in the documents attached.

FW 11.50.2 must be used for Single Controllers and 11.60.2 for Dual Controllers

If you would like to exclude certain Events and Alarms from being written in the BVMS logbook you do have the option to exclude such information.  

Find out from this article what to do when the Decoder VJD-7513 with FW 10.31.0005 is displayed in BVMS but: First monitor connected on HDMI to HDMI on monitor shows images. Second monitor connected via a USB-C-to-DP cable to the DP port on the monitor shows no output on the second monitor.

This article explains what to do when a black image occurs during the selection/ switching between Streams or by selecting the recorded videos (locally) when accessing Camera Trainer in Configuration Manager.

This article contains different Q&A regarding the Camera certificate in Config. Manager & WEB GUI: size limit, supported formats and limitations.

The maximum resolution of 5.3 MP can only be achieved with H.264 encoding

After a power outage/ reboot, all PTZ cameras will get back to their zero-point (home) position. If your PTZ camera was installed looking at a wall, in case of a power outage it will return to its home position where its image is pointing at the wall.

When entering in BVMS Operator Client, the camera's image is black and only Transcoding option is available for streams (no stream 1 or 2 , or image pane optimized) Desired result: See the camera's live image

“Error message” occurs while trying to upgrade the Firmware of VJD-7513 from firmware version 9.51 to 10.23. Configuration Manager 7.61 is used.

Never lose track of an object of interest! Intelligent Tracking automatically zooms in to and follows a selected Intelligent Video Analytics object as far as possible with the camera.

The RCP documentation can be found in the Firmware .zip file on the product page.

This feature is not available in BVMS 10.1. You cannot do it automatically for multiple cameras. You can do it one by one manually through Config Client.

This article lists the initial troubleshooting steps and concrete instructions for collecting logging for issues with ONVIF cameras, added to BVMS system. We will classify the different issue scenarios one can have using ONVIF cameras in BVMS system. Depending on the issue the article lists the required logging to start initial troubleshooting.

By subscribing to a specific topic on the Knowledge Base, you ensure that you receive timely updates and relevant information.

Find out from this article if is it possible to get a raw video stream from a Bosch camera

This article describes how to configure the Map-based calibration and Geolocation in different calibration methods

Due to the product design, the configuration of the NIR-50850-MRP (IP IR Illuminator 5000 MRP) is done only in the web browser. Also, this article contains a short explanation about how to setup the NIR-50850-MRP (IP IR Illuminator 5000 MRP).