This article describes the considerations that need to be taken into account when designing a video surveillance system that is suitable for person identification.
Check the sample script from this article. It is not a working script, that can be used directly. Follow the instructions in comments of the script to tailor it for your use.
If the Host Type was set to other value than “Factory Default” for DSA E2800 and you want to integrate it with BVMS, the targets will most likely not be scannable and there will be no recordings at all.
This article explains how you can configure the iSCSI ports of your DSA E2800 dual or single controller and afterwards configure it in BVMS Configuration Client.
This article describes how you can remove the existing BVMS or BVMS viewer configuration and generate a fresh configuration again in a situation the customer/installer is unable to remember the Admin login credential to the BVMS/ BVMS viewer.
This article lists the initial troubleshooting steps for issues with ONVIF cameras, added to BVMS system as Live Only ONVIF cameras. The specific point in this scenario is VSG is not used.
The present document is intended to provide information on the VRM camera replacement functionality in the Bosch Video Management System (BVMS), as well as guidance through the process
Use the Project Assistant to its full extent and once the cameras are connected to the target network, perform a network scan using the BVMS Configuration Client
